Grinding Series - SM120 Series Three Roll Grinding Machine

Grinding Series - SM120 Series Three Roll Grinding Machine：The grinding effect is achieved through the mutual compression of the surfaces of three horizontal rollers and friction at different speeds. The roller material of the three roll grinder is centrifugally cast from cold hard alloy cast iron, with a surface hardness of HS70 ° or above; The diameter of the roller is finely ground with high precision, which can achieve a grinding fineness of about 10 μ m for the material, thus producing uniform and delicate products.

Grinding Series - SM120 Series Three Roll Grinding Machine：It is an effective grinding and dispersing equipment for high viscosity materials. Mainly used for grinding various liquid slurries and paste materials such as paints, inks, pigments, plastics, cosmetics, soap, ceramic rubber, etc.Especially suitable for processing high viscosityProducts that require fine particle size are currently one of the devices with high grinding fineness in wet grinding equipment.

Equipment advantages:

1. The achievable fineness of grinding is one of the wet grinding equipment;

2. Manually adjust the roller gap, the mechanism is simple and reliable;

3. During the initial operation of the equipment, cooling water can be supplied to achieve a good cooling effect;

4. Suitable for processing high viscosity materials;

5. The roller is made of high wear-resistant bearing steel and processed through a series of processes such as forging, tempering, lathe, aging, quenching, and grinding;

6. The surface hardness is around H70

7. In addition, the roller can be made of ceramic material without metal ion pollution.

Maintenance of Three Roll Grinding Machine: After six months of continuous use, it is recommended to conduct a major overhaul of the three roll machine. The washing parts should be disassembled and cleaned, replaced with clean lubricating oil, and the smoothness of the oil circuit should be carefully checked. If any problems are found during disassembly and cleaning, they should be repaired in a timely manner. If the roller is found to be deformed during use, it must be stopped and re ground. If the number of roller grinding cycles is too high and the diameter of the roller is smaller than the requirement, it will cause the transmission gear to tighten and leave gaps between the rollers. At this time, the gears must be corrected.

The sharp edge of the discharge blade should be carefully corrected and polished before installation, with no burrs or cracks allowed. After the blade is short, the countersunk screw can be loosened and removed outward before use.