German factory takes ENS3116-3-0520-000-K Hedeke

German factory takes ENS3116-3-0520-000-K Hedeke

Features of HYDAC liquid level sensor:

Good stability, with a long-term stability of 0.1% FS/year at full and zero positions. Within the compensation temperature range of 0~70 ° C, the temperature drift is less than 0.1% 6FS, and within the entire allowable operating temperature range, it is less than 0.39% FS.

Equipped with reverse protection and current limiting protection circuits, the transmitter will not be damaged if the positive and negative poles are reversed during installation. In case of abnormalities, the transmitter will automatically limit the current to within 35MA.

Solid state structure, no movable parts, * reliability, long service life.

Easy to install, simple structure, economical and durable.

HYDAC liquid level sensor is used to record the liquid level in fluid technology systems. To meet a wide range of customer requirements, HYDAC offers a wide range of capacitive and non-contact level switches. The liquid level sensor records the liquid level and outputs one according to the preset output

Or multiple switch signals. As an option, the liquid level can also be used as an analog signal (4.20 mA or 0.10V).

The Hondec liquid level sensor ENS3000 series is an electronic liquid level switch with integrated display function. This device has 1.2 or 4 switch outputs and an optional analog output signal. In addition to the conventional minimum and maximum switches

In addition to the signal, the variant with 4 switch outputs can also be equipped with other warning signal messages to prevent, for example, fuel tank overflow or pump suction of air.

The ENS 3000 series can be used not only for oil, but also for water; Select the measurement medium in the application specific menu item. The main application of ENS 3000 is in hydraulic systems,

For example, used to monitor the liquid level of storage tanks. ENS 3000 is standard, with rod lengths of 250 mm, 410 mm, 520 mm, and 730 mm. Users with or without temperature sensors are welcome to use it

Use this device.

1. 2 or 4 independent PNP transistor switch outputs

Opportunity to choose between oil and water use

Free allocation of switch output to measurement variables

The switch point and reset point can be adjusted independently of each other

Reversible analog output

4-digit display

Easy to operate through menu guided key operations

Safety Notice:

Check the condition of the equipment and its accompanying accessories before debugging. Before starting the device, please read the operating instructions and put it into operation.

Ensure that the device is suitable for your application. Improper handling or failure to comply with usage or technical instructions may result in property damage and/or personal injury.

Rabbit Liability Statement

We have created these operating instructions to the best of our knowledge and belief. However, it cannot be ruled out that despite the greatest attention, errors may still be delayed. So please understand that we have not

There are other results, and our guarantee and responsibility are equal to excluding the information in this operation manual for legal reasons. Especially, we are not responsible for any loss of profit or other losses. Financial loss

Lost. This disclaimer does not apply to intent and gross negligence. It also does not apply to situations where it is maliciously hidden or where there is no guarantee that life will be severely damaged,

Body and health. If we neglect our contractual obligations, our liability is limited to foreseeable damages. The product liability from the claim is not affected.

Functions of HYDAC liquid level sensor ENS 3000 series

According to the version, the device provides the following functions:

Display the current horizontal measurement value in centimeters or inches (depending on the version)

Display the measured value of the current temperature in ° C or 'F' units

Display the minimum and maximum values of liquid level or temperature or a set switching point

● Switch parameters set according to the level or temperature switch output

● Analog output

Basic settings menu (to adapt ENS 3000 to their respective applications)

Programming version

German factory takes ENS3116-3-0520-000-K Hedeke