Gas cylinder water pressure detection device

WG-I typeGas cylinder water pressure detection deviceThe external testing method recommended in the standards GB9251-2011 Water Pressure Test Method for Gas Cylinders and GB24161-2009 Periodic Inspection and Evaluation of Composite Gas Cylinders for Respirators is used for testing the static water pressure and residual deformation of gas cylinders. The entire testing process is automatically controlled by the computer, and users only need to complete the test in three steps: "hoist in the gas cylinder - click start test - end test, hoist out the gas cylinder". Including locking the water jacket cover, water jacket exhaust and drainage, gas cylinder exhaust, gas cylinder pressurization, gas cylinder depressurization, unlocking the water jacket cover, all of which are automatically controlled by the computer without manual intervention;

Using PCI data card to achieve automatic data acquisition and testing control;

Set up a one click switch button for automatic/manual testing;

Can be tested manually and controlled mechanically without relying on computers;

Gas cylinder detection range: 2-12L gas cylinder;

The water jacket is made of high-quality stainless steel material, and the water jacket cover is pressed at three points;

Maximum working pressure: 69MPa;

Air supply pressure: 0.6-1.0MPa;

Verify pressure gauge accuracy: 0.4 level;

Pressure sensor accuracy: 0.25 level;

Electronic balance accuracy: 0.01 grams;

Imported stainless steel high-pressure valve, working pressure 250MPa;

Imported maintenance free booster pump, with a maximum working pressure of 86 MPa;

Number of water jackets: 1

Dimensions of the operation console: 1110mm × 730mm × 1640mm

Dimensions of the water jacket: Ø 720mm × 1300mm

WG-I typeGas cylinder water pressure detection deviceConfiguration checklist: 1 control panel (including electronic balance, computer host, monitor, printer), 1 water jacket