Fire safety assessment instrument

Beijing Penglichi Technology Co., Ltd. specializes in providing fire assessment and testing equipment, including pass through, report, smoke analyzer, smoke density meter, radiant heat flux meter. The software required for assessment includes but is not limited to: personnel evacuation capability simulation analysis software, smoke flow simulation analysis software (CFD), structural safety calculation analysis software, etc

The PRT-Y90 building materials smoke density tester is designed according to the national standard GB/T8627-2007 "Test Method for Smoke Density of Building Materials during Combustion or Decomposition". Its test principle, test steps, sample preparation, etc. are all taken from this standard. Reading GB/T8627-2007 in detail before the test will provide sufficient guidance for your use.

Please be aware that the following items may be involved while using the instrument:

1Please read the relevant standards and equipment manual before using the equipmentThe instrument should have a grounding wire when using the specified voltage.

IIIt is strictly prohibited to connect any other gas that does not match the device!!!

IIIWhen testing samples, certain materials may release toxic and harmful gases. It is recommended that testing should be conducted in a well ventilated environment and proper human protection measures should be taken.

4When using gas sources such as liquefied gas, natural gas, and coal gas, there should be no air leakage at each pipeline interface, and the ventilation pipe should be replaced in a timely manner if it is aging. useWhen using a "perpetual light" as a source of ignition, be sure to first light the "perpetual light" and then open the relevant gas valves.

5During the experiment, operators are not allowed to leave the testing site.During the experiment, experimenters should be careful to prevent burns caused by high temperatures!

VIComputer controlled devices should be protected against virus invasion.

7Flammable and explosive materials other than those required for testing are strictly prohibited in the laboratory!

8The laboratory needs to be equipped with fire-fighting equipment

9At the end of the experiment, all power and gas sources should be turned off.Please make sure to clean up any test residues or drips!

1Overview

PRT-Y90 Smoke Density MeterAccording to national standardsDeveloped according to the technical conditions specified in GB/T86272007 "Test Method for Smoke Density of Building Materials during Combustion or Decomposition". Compared to the original instruments that use microcontroller technology to achieve testing functions, this product has the following characteristics:

1)Dual control mode, can be controlled on the touch screen or operated on the computer, and the operation mode can be switched freelyOne device can be operated by multiple computers simultaneously, multiple computers can be online at the same time, and LAN sharing can be achieved

2)The main and auxiliary burners can rotate automatically with accurate positioning.

3)Each device is equipped with three standard filters, which are representative of the data calibrated by the light source.

4)The instrument has a reasonable structural design, easy operation and maintenance, and is suitable for measuring the static smoke production of building materials and their products, as well as solid materials during combustion.