FS-100 Intelligent Integrated Flame Detection System

1FS-100 Intelligent Integrated Flame Detection SystemIntroduction

The FS-100 intelligent integrated flame detector is based on microprocessor and bus technology. It detects the target flame light signal through the installation of IR (infrared) sensors or UV (ultraviolet) sensors to determine the presence/absence of the burner target flame, ensuring that the fuel supply is stopped when the boiler is extinguished. This system is widely used in industries such as power generation, refining, chemical, steel, cement, etc., and is suitable for continuous detection of single or multi fuel burner flames in various industrial furnaces such as power plant boilers, fluidized bed boilers, coal powder boilers, and kilns.

IIFS-100 Intelligent Integrated Flame Detection Systemfeature

Self checking and self-learning functions;

Fault alarm, password protection, frequency selection function;

Integrated structural design, easy to install and debug, with minimal maintenance;

Install PTFE professional insulation material to improve equipment temperature resistance parameters and extend equipment service life;

Using high-performance photosensitive devices, spectral response range: UV type: 190nm-380nm, IR type: 700nm-1700nm;

Equipped with network functionality: capable of remote online adjustment and parameter setting;

A professional engineering installation service guidance team ensures that fire detection does not peek;

Can store 8 sets of files, suitable for different loads, fuels, and combustion technologies

3、 Technical indicators

1Conduit components

Perspective: Coal Fire Inspection 7^o～10^oOil and fire inspection 5^o～7^o；

Environmental temperature: (-40~600) ℃

Spectral range: (190-380) nm (UV type), (700-1700) nm (IR type)

Transmittance:>85%

Catheter structure: direct view and fiber optic

2Flame detector

Display interface: 8-character LED;

Analog output: (4-20) mA;

Environmental temperature: (-40~85) ℃;

Environmental humidity: (0-95)% relative humidity, non condensing;

Protection level: NEMA 4X IP66

Contact output: flame relay (normally closed), fault relay (normally closed);

Contact capacity: 30VDC/2A, 125VAC/0.6A;

Maximum load: 750 Ω;

Input power supply: 24VDC ± 10%, 0.35A;

Installation method: threaded connection method;

Shell weight: approximately 1.8kg;

3Cooling/blowing air

Flow rate: (5-15) SCFM ((141.5-424.5) Nm/min);

Pressure: 6Kpa;

Cooling air source: clean and dry cold air source

configuration

The system consists of duct components, flame detectors, local junction boxes, power cabinets, and cooling air systems.