Coarse grained soil consolidation instrument

NegotiableUpdate on 01/10

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Coarse grained soil consolidation instrument is an industrial instrument used to determine the compressive properties of soil under different loads and limited conditions. It can perform normal slow consolidation tests and rapid consolidation tests, and measure the pre consolidation pressure and consolidation coefficient.

Product Details

　　Coarse grained soil consolidation instrumentIt is an industrial instrument used to determine the compressive properties of soil under different loads and limited conditions. It can perform normal slow consolidation tests and rapid consolidation tests to determine the pre consolidation pressure and consolidation coefficient.

　　Coarse grained soil consolidation instrumentThree types of experiments can be conducted: a) undisturbed soil - on-site soil sampling; b) Reshaping soil mud pre consolidated soil; c) Heavy compaction of soil - static compaction or dynamic compaction.

Control and post-processing, easy to use.

Especially smaller initial loads (1-2kPa) can also be controlled.

It can ensure a more accurate consolidation rate.

Software fully automatic control, automatic data collection and analysis.

RS485 high-speed bus, one computer can connect up to 1024 consolidation instruments.

1. And position the lever between the lifting brackets to prevent friction.

2. Prepare soil samples according to geotechnical testing procedures.

3. After installing the protective ring, place the prepared soil sample onto the permeable stone in the container, then place the permeable stone, pressure plate, and steel ball on the top, place them in the center of the pressure frame, and install the dial gauge.

4. Rotate the handwheel clockwise to raise the lifting rod to its peak, and then rotate it counterclockwise by 1-2 turns.

5. Align the pressure head with the steel ball and adjust the nut at the lower end of the pull rod so that the container can be freely removed and placed when the frame is raised.

6. Apply a preloading load of 1 first to make the pointer reading zero. Gradually increase the load in the future (remove the preload weight before adding).

　　7. After loading, observe the sinking of the lever or rotate the handwheel counterclockwise as needed to adjust the lifting rod to maintain the balance of the lever.