CSR matching speed sensor

CZC-1 Speed Sensor Product

CSR matching speed sensorcharacteristic

1 Introduction

The CZC-1 speed sensor product adopts the Hall effect. When the metal teeth pass through the front end of the Hall sensor, it causes a change in the magnetic field. The Hall element detects the change in the magnetic field and converts it into an alternating electrical signal. The built-in circuit of the sensor amplifies and shapes the signal, outputting a good rectangular pulse signal. The measurement frequency range is wider, the output signal is more stable, the installation is simple, and it is oil and waterproof. It has been applied in speed measurement fields such as electricity, automobiles, aviation, textiles, and petrochemicals

2 CZC-1 Speed Sensor Product Technical Parameters

2.1 Working voltage: DC5-24V

2.2 Measurement range: 0-20KHz

2.3 Speed measuring gear form: module 2-4 (involute gear)

2.4 Output signal: Square wave, whose peak to peak value is equal to the amplitude of the working power supply voltage, independent of the speed, with a maximum output current of 20mA

2.5 Working temperature: -30 to+150 ℃

2.6 Thread specification: Φ 18 sensor (installation thread: M18 × 1) can be customized according to requirements

2.7 Installation gap: 1-2mm

CZC-1 Speed Sensor Product Features

CSR matching speed sensorFeatures:

1. Inductive iron metal targets

2. Digital current sink output (open collector)

3. Better signal-to-noise ratio than magneto electric sensors

4. Low speed performance and high-speed performance, output signal above 0-100KHz, amplitude independent of speed

5. Anti electromagnetic interference

For active three wire sensors:

1. The sensors are labeled with positive input, negative COM, and power supply (applicable to DC+12V-24V)

2. Rotating machinery equipment requires one QBJ-CS-2-2 sensor to measure positive rotational speed; If it is necessary to measure the reverse speed, use 2 CS sensors

3. The QBJ-CS-2-2 sensor can measure forward or reverse rotation, and the two sensors can be interchanged. When installed, they are clamped at a 90 degree angle, and the end face of the sensor is perpendicular to the measured tooth

Wheel surface, installation distance: between 0.5 and 0.8mm

4. Gear material requirements: Various magnetic conductive steel materials are acceptable

Gear module: 1.5 or above is sufficient

5. Measurement object: 1 slot, 3 teeth, 30-120 teeth (can be customized by the user)

6. Sensor installation thread: M16 × 1

Sensor screw length L: 60-200mm (can be customized by the user)

7. The sensor leads are labeled with (positive input, negative COM, power supply DC+12V) and should be connected to the instrument terminals