CFO2100 Milk Factory Tuning Fork Switch

CFO2100 Milk Factory Tuning Fork Switch

NRP small tuning fork level switch radar level gauge

NRP small tuning fork level switch radar level gaugeProduct Introduction:

NRPThe tuning fork type level switch is a new type of level switch. The instrument consists of a transmitting fork and an amplifier section, with two sets of piezoelectric crystals pressed at the base of the fork. One set serves as a driver to drive the fork to produce vibration, while the other set serves as a detector to convert the fork into a voltage signal. When the fork is obstructed, the amplitude of the vibrator decreases, the vibration frequency changes, and the relay outputs a switch signal. Thus achieving level limit measurement. The sensor material is316 stainless steel, resistant to mild corrosion, used for limit controllers and high/low level alarms.

CFO2100 Milk Factory Tuning Fork SwitchTypical applications:

● Tap water, mineral water ● Liquids that can produce gas ● Pulp, glue, dyes ● Beer, beer starter, beverages

● Wastewater, mud, acid-base solutions ● Hazardous areas such as diesel ● Solid powders with good fluidity

unboxing

Carefully open the packaging box and remove the filling inside. Carefully check each item on the packing list, including instrument model, installation accessories, instructions, etc If you find any shortage, discrepancy with the packing list or damage, please contact our company immediately.

2、 View the instruction manual

This manual includes the technical parameters, installation and commissioning specifications of the instrument. Please carefully read each item in the manual. If you have any questions about the content in the manual, you can contact our company by phone or fax.

3、 Technical parameters

Power supply: 24VDC ● Environmental temperature: -20 ℃~70 ℃

Output mode: Relay output (normally open or normally closed) ● Medium temperature: -40 ℃~85 ℃

Work pressure: less than 2MPa ● Medium density: 0.6g/cm³

● Delay: 1-60s (optional) ● Shell protection: IP66

Power consumption: 0.5W ● Electrical interface: Hirschman interface

● Process connection: NPT3/4”Threaded installation (standard thread) flange installation, other threads (optional)

4、 Electrical wiring

6、 Testing

When leaving the factory, the alarm is usually set to a high position. Connect the tuning fork type level switch to the power supply, lift it up, and insert it vertically into the water. The insertion depth should be greater than25mm， At this point, the output relay is closed; Lift the tuning fork away from the water surface and disconnect the output relay, indicating that the instrument is working properly.