Baode solenoid valve 00125304 for spot sales

NegotiableUpdate on 05/14

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

BURKER solenoid valves can be universal, but economical products should be selected on the basis of meeting the above three points. The selection of solenoid valves should first follow the four principles of safety, reliability, applicability, and economy. Secondly, the selection should be based on six aspects of on-site conditions (i.e. pipeline parameters, fluid parameters, pressure parameters, electrical parameters, action mode, and special requirements).

Product Details

Baode solenoid valve 00125304 for spot sales

The performance characteristics of BURKERT Baode solenoid valve are that the groove butterfly valve is coated with epoxy resin as a whole, which has strong resistance to corrosion and rust. It can not only supply raw water, but also be used in sewage systems. The groove butterfly valve has grooves at both ends and is connected to the fluid pipeline with clamps. Compared with previous flange or clamp connections, it greatly saves manufacturing materials and follows China's energy-saving and emission reduction strategy policies. If the flow rate of the system is found to be too high or too low, it may be due to debris stuck on the valve plug during the installation of pipeline components. The 1/2 'ball valve can be closed for 3-5 minutes. If it is a minor blockage, it can be automatically eliminated. If it still cannot be eliminated, the valve should be opened to check and eliminate the blockage. Due to the wiping nature of the movement of the groove butterfly valve plate, most butterfly valves can be used for media with suspended solid particles. Depending on the strength of the seal, it can also be used for powdered and granular media. The butterfly valve has a relatively small structural length and overall height, with fast opening and closing speed. When opened, it has a small fluid resistance, and when opened to approximately 15 ° to 70 °.

Technical Specifications

Internal hole DN 12-25 mm

Valve body material: brass

Coil material polyamide

Coil insulation grade B (H to be provided as needed)

Valve internals made of stainless steel and brass

Sealing material NBR, PTFE valve seat sealing

Neutral medium, compressed air, water, hydraulic oil

Medium temperature -10 to+90 ° C

Environmental temperature Max.+55 ° C

Voltage tolerance ± 10%

Load cycle 100% continuous operation

Electrical connection DIN EN 175301-803 A-shaped (formerly DIN 43650) pins,

Equipped with 2508 cable plug (refer to the attached order table on the next page)

Protection level IP 65, when the cable plug is plugged in

The installation position can be adjusted as needed, preferably with the actuator facing upwards

Performance:

Two position two-way solenoid valve

Equipped with servo piston, suitable for high pressure

G1/2-G1

Features:

• Equipped with servo piston solenoid valve

The maximum pressure can reach 50 bar

• Push rod coil

Product Introduction:

Baode Burkert 5404 Pilot Control Solenoid Valve with Servo Piston, Constant

Closed type, suitable for controlling high-pressure gases and liquids.

To open the valve, at least 1 bar of pressure is required

Poor.

Baode solenoid valve 00125304 for spot sales