Second generation carrier high-speed USB programmer FPGA simulation programmer

The ispVM System/Diamond/Radiant Programmer software automatically generates corresponding programming commands, programming addresses, and programming data based on the information stored in the programming file and the parameters set in the Diamond/Radiant Programmer/ispVM System. Then, the programming signal is generated from the USB or parallel port of the PC and transmitted directly to the device through the programming cable. Programming does not require additional components.

Lattice's programming cable can be connected to multiple PC interfaces, including USB (v.1.0, v2.0) or PC parallel ports, and connected to the target board using a multifunctional fly wire connector. Comes with an adapter to help organize fly wires into 2 x 5 (. 100 ") or 1 x 8 (. 100") connector configurations. All cables comply with lead-free/RoHS standards.

Note: Port A is used for JTAG programming. Radiant programming software can use built-in cables through a USB hub on a PC, which will detect the USB functional cable on port A. Port B is used for UART/I2C interface access. The Diamond Programmer/Radiant Programmer/ispVM system software is included in all Lattice design tool products

Lattice provides programming cables:

• New USB programming cable:HW-USBN-2B

• First generation USB programming cable:Hw-usbn- 2 A

• Parallel PC programming cable:HW-DLN-3C

For complete specifications and further instructions, please refer to the programming cable user guide linked below, as well as the online help included in Radiant and Diamond Programmers.