The fully functional Shore hardness tester brings benefits to enterprises
Fully functional Shore hardness testerThe instrument is suitable for measuring the hardness of vulcanized rubber and plastic products. It has the characteristics of simple structure, convenient use, lightweight body, and intuitive reading. The product meets the requirements of other relevant standards and can be carried for handheld measurement or installed on the supporting testing rack for use.
The full function Shore hardness tester is suitable for measuring the hardness of low hardness materials such as foam, sponge, and microporous materials for shoes. It can not only be carried around for hand-held measurement, but also be installed on the supporting test rack. It is suitable for hardness testing of high hardness rubber and plastic materials such as general hard rubber, hard resin, organic glass, thermoplastic plastics, printed boards, fibers, etc.Fully functional Shore hardness testerUntil the bottom surface of the hardness tester comes into contact with the specimen *, the scale pointed by the pointer is the hardness value of the specimen (test piece). To stabilize the measurement conditions and improve the measurement accuracy, the hardness tester device should be tested on a fixed load measuring rack of the same model produced by the manufacturer. Three points should be selected at different positions for each measurement, and the arithmetic mean should be taken.
Press down the right handle of the full function Shore hardness tester, raise the worktable until it comes into contact with the glass table, place the sample, and the same can be done to obtain the change of the sample. Before measurement, check that the pointer of the hardness tester is at zero position in the free state. asFully functional Shore hardness testerWhen the pointer deviates from the zero position, you can loosen the upper right corner compression screw, rotate the surface, align with the zero position, and press the hardness tester on the glass plate. The pointer should point to 100 degrees. If it does not point to the zero position or 100 degrees, you can lightly press the pressure needle several times. If it still does not point to the zero position or 100 degrees, it cannot be used. If it is used on a fixed load frame, you can move the handle to raise the worktable, insert the positioning pin into the small hole at the bottom of the worktable, adjust and use it. If it still does not refer to 100 degrees, it cannot be used and needs to be adjusted.
The adjustment of the fully functional Shore hardness tester requires weights and calibration devices, so it is advisable to send it to the production unit for adjustment. After use, it should be placed in the instrument box or instrument box and placed in a dry place to prevent moisture. The lifting small shaft on the fixed load measuring rack and the bottom of the workbench should be wiped clean regularly and coated with a small amount of anti rust oil to prevent rusting.
