Bus duct, vacuum oil filter * Power represents the future of technology

1、 Bus duct, vacuum oil filter * Power representative technology future overview

In order to meet the needs of on-site maintenance of various high and low voltage oil carrying equipment in the power maintenance department, we refer to the technology of Japan's Kato Company and Germany's Siemens Company, strictly follow the national standards guided by DL/T521-93-2002 Vacuum Oil Purifier Usage Guidelines, and design an ideal equipment for filtering water, gas, and impurities in various oils such as transformer oil, turbine oil, oil below 40 ℃, hydraulic oil, lubricating oil, and machine oil, which has the characteristics of small volume, light proportion and weight, easy movement, low noise, long continuous working time, stable performance, and easy operation.

2、 Bus duct, vacuum oil filter * Power represents the future main applications of technology

1. This machine can be used for on-site oil filtration and replenishment of various oil immersed transformers, oil immersed current transformers, voltage transformers, and low oil relays.

2. This machine can be used for on-site hot oil circulation drying of the above equipment, especially for oil immersed current, voltage transformers, and low oil circuit breakers, which are more effective in hot oil circulation drying.

3. This machine can be used for on-site vacuum oil injection and replenishment of sealed oil immersed equipment, as well as equipment vacuum pumping.

4. This machine can also be used for regenerating and purifying mildly deteriorated transformer oil to achieve qualified oil performance standards.

3、 Bus duct, vacuum oil filter * Power represents the main characteristics of future technology

Compared with similar products in China, this machine has the following characteristics:;

1. Small in size and lightweight, it is half the weight of similar products.

2. Improved the design of oil and gas separation. By using vacuum fuel injection and installing a tubular rotating injector, resistance is reduced, the swirling speed is fast, and the oil and gas separation effect is increased.

4. According to the user's needs, the filter medium of the oil purifier is made of a specially designed fine filter element, which is made of non-woven dense paper. When slow filtration is found, simply peel off the outer layer of non-woven dense paper.

5. One machine has multiple functions, which is an important feature of this machine. Due to the on-site use of this machine and the use of the original oil carrying equipment as a storage tank, the hot oil is circulated between the machine and the equipment, allowing for the simultaneous functions of oil filtration, regeneration, and hot oil circulation drying, saving labor, time, and achieving three benefits at once.

4、 Working principle

The vacuum oil purifier is designed based on the different boiling points of water and oil. It consists of a vacuum heating tank, a fine filter, a condenser, a primary filter, a water tank, a vacuum pump, an oil discharge pump, and an electrical cabinet. The vacuum pump will draw out the air inside the vacuum tank to form a vacuum. Under the action of atmospheric pressure, the external oil enters the primary filter through the inlet pipeline to eliminate larger particles, and then enters the heating tank. The oil heated to 40-75 ℃ passes through the automatic oil float valve, which automatically controls the balance of the amount of oil entering and leaving the vacuum tank. After heating, the oil is separated into a semi mist by the rapid rotation of the spray wings. The water in the oil evaporates rapidly into water vapor and is continuously sucked into the condenser by the vacuum pump. The water vapor entering the condenser is cooled and then returned to its original form before being released. The oil in the vacuum heating tank is discharged into the fine filter by the oil discharge pump and filtered out of particulate impurities through the filter element. Thus completing the entire process of quickly removing impurities, moisture, and gases from the oil in the vacuum oil filter, allowing clean oil to be discharged from the outlet of the machine.

5、 Instructions for use

Connect the inlet and outlet oil pipelines, connect 380V, connect the safety ground wire, check whether each circuit is reliably connected, whether each oil valve is open, and prepare for the operation procedure only after there are no defects; Start the vacuum pump to ensure that the oil inside the pump can operate normally, and then continue to operate the vacuum pump continuously. When the vacuum surface reaches the gauge *, the oil inlet valve can be opened until the oil level is visible in the lower window of the vacuum cylinder. Then, the oil discharge pump switch is started to filter impurities and the oil circuit circulates normally. The heater switch is turned on to evaporate the water in the oil. If there is a lot of water in the oil, the oil foam in the vacuum cylinder will increase. At this time, the vent valve must be opened to control the appropriate vacuum degree. After the water decreases and the oil drops, the vent valve must be closed to reach the limit of vacuum degree. At this point, attention should be paid to the reactions of various instruments. If the pressure gauge reading is greater than 0.3MPA, it indicates that there are too many impurities on the surface of the filter element in the oil filter. The surface filter paper needs to be removed. After the work is completed, refer to the schematic diagram, open the vent valve to achieve normal atmospheric pressure, drain the oil in the cylinder, and release the remaining oil from the drain valve to prevent mixing with different types of oil in the next use.

6、 Technical standards;

7、 Structural schematic diagram;

1One of the schematic diagrams of the working principle of the vacuum oil filter; （DZJ－16～25Two specifications)

2Working principle diagram of vacuum oil filter II; （DZJ－30～50two specifications）

3Working principle diagram three of vacuum oil filter; （DZJ－80～200Five specifications)

8、 Precautions

• The power supply must be connected to the ground wire before operation.
• When operating, pay attention to the direction of motor rotation, which should conform to the direction of the arrow.
• When there is no oil circulation, do not start the heater, otherwise it will burn out the heater and explode if it is too heavy.
• Before draining oil, all valves in the oil outlet pipeline must be opened.
• The working environment temperature should not be used if it is below minus 30 ℃ or above 40 ℃.

9、 Common faults and their elimination methods

10、 Random accessories

1. A copy of the instruction manual.
2. One copy of packing list (with certificate of conformity).
3. One inlet and outlet oil pipe each.

According to data, the number of homeless people in Los Angeles has increased over the past year20%In Los Angeles County, this number is23%.

British Broadcasting Corporation（BBC）6moon1According to experts, the increase in rent and living costs is the main reason for the rising number of homeless people in this area.

Los Angeles County Councilor Janice Hahn said the new numbers are "staggering".

She wrote in the statement, "The number of homeless people in Los Angeles County is increasing at an alarming rate

She said that despite the government's efforts to help thousands of people leave the streets and return to their homes, the number of homeless people is increasing. "Obviously, if we want to end this homelessness crisis, we need to stop the trend of people falling into homelessness.

Los Angeles has always been a homeless issue in the United States. Los Angeles Homeless Services Bureau1993Established in the year, specifically designed to address this issue.

　　2015In the year, the number of homeless people in this area surged. The city of Los Angeles immediately promised to invest1Billions of dollars to solve this problem.

However, this trend has not been reversed. The Los Angeles Homeless Services Bureau wrote in its report that this year1In the survey conducted this month, homeless individuals in Los Angeles County57794People. This number is2016Year for46874People.

Los Angeles Mayor Eric Gacheti believes that high rent and urban living costs are part of the reasons for the worsening situation.

according toBBCThe provided data, from2000Since the beginning of the year, the average rent in Los Angeles County has increased32%The average household income of tenants has decreased after adjusting for inflation3%The low-income group is approximately70%The income is used for renting.

The Los Angeles Homeless Services Bureau calculates that Los Angeles County needs to build more than55Ten thousand low rent residential units for low-income individuals to live in.

Los Angeles recently approved financing through bond issuance12Billion dollars, newly built for homeless people1Ten thousand residential units.