Microfluidic injection pumps can choose working modes; You can select a syringe from the list or directly input the inner diameter parameter of the syringe; Can directly input the injection volume; You can directly input the injection flow rate. When all working parameters are set, click the OK button to jump to the running interface. Press the run button, and the infusion pump will start running. The running status can be displayed through parameters such as progress bar and running time.
Microfluidic injection pumps are widely used in laboratories, especially in biomedical, chemical, and physical fields, where they can precisely control liquid flow. The general usage method is as follows:
Prepare equipment: Ensure that the infusion pump and the microfluidic chip or piping system used are properly connected.
Loading liquid: Load appropriate reagents or liquids into the inlet tube of the infusion pump as needed. Ensure that the liquid does not produce bubbles.
Set parameters: On the control panel of the infusion pump, set the required parameters such as flow rate, pressure, and volume. Different experiments may require different flow rates or volumes.
Calibration: Perform necessary calibration based on the viscosity and flow rate requirements of the liquid used. Usually, it is necessary to verify the accuracy of traffic through experiments.
Start the infusion pump: Start the pump and monitor the flow situation. Ensure stable flow rate and avoid excessive pressure or leakage.
Real time monitoring: Use the pump's built-in display screen or external instruments to monitor flow rate, pressure, and other possible variables.
Stop using: After the experiment, turn off the infusion pump and clean the equipment. Regularly check the equipment status to ensure accuracy and reliability for long-term use.