Super Depth of Field MicroscopeThe depth of field of the microscope can be increased by several hundred times, greatly simplifying the preparation requirements of microscope samples. The super depth of field microscope can obtain the three-dimensional morphology of the sample, and can perform three-dimensional reconstruction and measurement. Super depth of field microscope is a representative of three-dimensional optical digital microscope. The three-dimensional morphology of the sample can be obtained, and three-dimensional reconstruction and measurement can be performed,Super Depth of Field MicroscopeCan be applied to experimental research in the fields of semiconductors, micro nano devices, mechanical manufacturing, materials research, etc; Such as 3D morphology analysis of microchips, 3D morphology of etched samples, packaging materials, data analysis of binary optical devices, surface measurements of mechanical, optical, coating, heat treatment, 3D measurement analysis of material micro indentation, evaluation of wear surface quality, measurement of film thickness, analysis of material fracture surface, research on metal materials and composite materials, biomaterials, etc.

There may be many misunderstandings when using a super depth of field microscope. Although the operation is not very complicated, many details cannot be ignored, otherwise it will affect the results of use. The following is a summary of the initial useSuper Depth of Field MicroscopePossible non-standard operations and correction of incorrect methods.

1) When picking up and delivering a super depth of field microscope, one hand holds the microscope arm. Correct method: Hold the mirror arm with your right hand and hold the mirror holder with your left hand.

2) Remove the reflector and eyepiece and touch them randomly. Correct method: Do not do this after removal, just leave it on.

3) Not placing or replacing the eyepiece in a timely and rapid manner. Correct method: When removing the lens cover or eyepiece with one hand, place the eyepiece with the other hand.

4) When placing or replacing the eyepiece, pinch the lens with your fingers. Correct method: Pinch the upper part of the eyepiece tube with the index finger and thumb.

5) Use the objective lens to rotate the converter. Correct method: Use the index finger and thumb to pinch the rotating disc of the transducer to convert the objective lens.

6) Wipe the lens with your fingers. Correct method: Use lens paper to wipe in one direction without touching the lens with your fingers.

7) After the experiment is completed, directly place the super depth microscope into the mirror box. Correct method: After use, use velvet cloth and lens paper to wipe the various components and lenses of the microscope clean, cover the lens cover, and rotate the converter to make the two objective lenses offset to both sides, so that the microscope is in a "resting" state, and then put it into the mirror box.