Testo 350 flue gas analyzerAccurate readings, robust design, and easy operation are the basic requirements for measuring tools as professionals conducting fast and reliable combustion equipment testing and combustion efficiency analysis on site.

Testo 350 flue gas analyzerProvide reliable heating system testing, flue boiler testing, engine testing, etc. to meetMultiple measurement requirements such as smoke measurement, differential pressure measurement, flow rate measurement, etc. Equipped with a backlit display screen, suitable for various lighting conditions.The sensor automatically resets to zero in just 30 seconds. The replacement of the smoke and dust filter element is extremely simple. Built in condensation tank for wastewater collection, which can be quickly emptied.

Compare, analyze and investigate the reasons

Our company conducted on-site testing at a certain location and found that the online oxygen concentration monitoring equipment at the denitrification inlet was not calibrated, resulting in a low excess air coefficient calculated, which led to a lower conversion value of nitrogen oxide concentration.

Meanwhile, it was unexpectedly discovered that the online smoke monitoring equipment displayed a smoke temperature that was 20 ℃ lower than the actual temperature. The technicians promptly corrected the parameters and notified the boiler operators to adjust the combustion conditions of the boiler, as high flue gas temperature can reduce the thermal efficiency of the boiler and cause the failure of the denitrification catalyst.

After the adjustment is completed,CEMS displays numerical values andThe testo 350 flue gas analyzer shows the same value.

Testo350 Smoke Analyzer Orange Edition

Testo350 has been upgraded to the orange version. It can be widely used in measurement conditions such as high temperature, high humidity, high dust, and ultra-high/low concentration gases.

✔ Up to 6 sensors can be expanded, with high/low range sensors to choose from. The detection and measurement limits of low range sensors are more in line with customer expectations.

✔ When encountering special high concentration gas conditions, activate the range extension function without worrying about sensor poisoning or interrupting measurements.

✔ It can be directly connected to the internal data network through an analog signal output box.

✔ Easy to carry, no need to connect to mains power on site, start measuring operations immediately without waiting.

In addition, with the testoeasymEmission software, measurement data can be stored on a computer for archiving and analysis. The measurement data can be printed on site.