Pure air generatorWe can provide dry and pure compressed air for your laboratory instruments; The A-series pure air generator uses a precision filtration system and a hydrocarbon removal device to remove oil stains, impurity particles, and hydrocarbons from compressed air, obtaining clean air. Then, it uses a new membrane dryer with a non-traditional drying tube to obtain a dry compressed air source with a dew point of -45 ℃. Pure air generators can be widely used in laboratory equipment that requires ultra dry and ultra clean compressed gases, such as NMR, FT-IR, AA, TOC, etc. Features: Built in oil-free compressor, no need for external air source. After multi-stage purification, the air is purer, drier and noise resistant. Low noise. The system is equipped with a two-stage pressure protection device for safe operation
Pure air generatorFeatures:
1. The instrument is equipped with an HL-A device, which automatically adsorbs and removes hydrocarbons, esters, oils, etc. from the air, greatly improving the quality of the air without maintenance.
2. Stainless steel storage tank, automatic drainage (to prevent the discharge of yellow rust pollution during actual testing).
3. The airflow section is entirely made of stainless steel pipes (electrolytic polishing, ultrasonic cleaning).
4. Low pressure start-up effectively improves the lifespan of the compressor.
5. Small size. Low noise, especially suitable for laboratory use.
6. Dual filter, two-stage voltage stabilization, high output pressure accuracy, and complete protection measures.
Pure air generatorOperation guide:
(1) First, unscrew the plug on the air inlet and replace it with a dust filter. Tighten the pressure cap on the air outlet and seal the outlet.
(2) Connect the power and start the instrument. The pressure gauge shows a gradual increase of 0.4MP, and the air compressor continues to work for a moment before stopping. At the same time, the working indicator light of the air compressor goes out.
(3) Next, slowly loosen the pressure cap on the air output port until the air starts to be discharged. After a moment of discharge, the air compressor can restart again. The instrument is operating normally.
(4) Online connection: First turn off the power, then remove the sealing cap on the air outlet and release the air. Connect the instrument with a pure pipe with an outer diameter of 3mm or 1/8in, and then start the instrument to use it.