1Alicat flowmeterUse core prerequisites

Before use, it is necessary to confirm that the equipment model matches the tested medium (gas/liquid), check that the installation interface is well sealed, and that the power supply voltage meets the equipment requirements (usually 12-24V DC).

IIAlicat flowmeterBasic operation steps

Installation and connection: Connect the pipeline according to the flow direction to ensure that there is no leakage at the interface and to avoid stress transmission from the pipeline to the equipment body.

Power on startup: Connect the power supply, enter the default measurement mode after the device self-test is completed, and wait for the value to stabilize (usually within 30 seconds).

Parameter viewing: Read core data such as instantaneous flow rate, cumulative flow rate, and pressure through the display screen, and switch display units by pressing the function keys.

Simple setup: If you need to adjust the measurement unit (such as L/min, m ³/h) or alarm threshold, complete the configuration through panel buttons or supporting software.

Shutdown Closing: After the test is completed, turn off the medium source first, wait for the pipeline pressure to be relieved, and then disconnect the equipment power supply.

3、 Precautions for use

Avoid mixing particulate impurities or corrosive substances into the medium, and install filters if necessary.

Do not strike or violently vibrate the equipment during operation to prevent affecting measurement accuracy.

When not in use for a long time, disconnect the power supply and seal the pipeline interface to prevent dust or moisture from entering.

4、 Common problem troubleshooting

No data display: Check if the power connection is reliable, confirm if the device is in standby mode, and try unplugging the power again.

Large data fluctuations: Check whether the pipeline leaks, whether the medium is stable, and restart the equipment to calibrate the zero point if necessary.