The charging interface cable bending test machine can accurately capture various parameter changes of the cable during the testing process, ensuring the accuracy and reliability of the test results, allowing users to obtain reliable data to judge the quality of the cable. Supports multiple testing modes, including constant bending angle testing, cyclic bending testing, etc. Users can also customize testing parameters according to their own needs, meeting the diverse needs of different users and increasing the applicability of the equipment.

The use of high-performance electrical control systems and stable mechanical structures not only ensures the stability and reliability of the testing process, but also has fast start and stop functions, greatly improving testing efficiency and saving time and labor costs. We strictly adhere to relevant safety standards and specifications during the design and manufacturing stages, equipped with various safety protection devices such as overload protection, overcurrent protection, etc., effectively responding to emergencies and ensuring the safety of users during use.

Some devices are equipped with touch screen settings and dynamic curve display functions, which facilitate users to intuitively set parameters and view test progress; At the same time, some devices also support functions such as automatic reset and data saving, further simplifying the operation process. The parameters such as bending angle, speed, and frequency can be adjusted according to specific testing requirements, which enables the testing machine to simulate various practical use scenarios and better evaluate the performance of cables under different conditions.

Precautions for using the charging interface cable bending tester:

1. Pre startup inspection and debugging

-When opening the box for testing, all working shafts and bending sleeves should be removed first for no-load operation. Personnel who have not received specialized training should be extra careful when turning on the machine. They need to press the "jog forward bending", "jog reverse bending", "automatic forward bending", and "automatic reverse bending" buttons respectively, and observe whether the direction and angle of the work wheel are the same as the set. If the rotation direction of the work disk is different from the set direction, the power should be immediately cut off and the electrical personnel should adjust the direction of the motor power supply. If other abnormal situations occur during the trial operation, the machine should be quickly shut down or the main power should be turned off. It can only be used again after professional personnel have debugged and repaired it.

The Importance of Safety Devices

-Ensure that the limit device of the equipment is working properly. Before use, the position of the limit block must be adjusted correctly according to the two adjustment methods in the manual, which is an important guarantee to prevent accidents in case the electrical control system loses control.

3. Maintenance of button functions

-When either the switch button or the emergency stop button is damaged, it should not be continued to be used and electrical personnel should be notified promptly for repair.

4. Operating standards

-Throughout the entire experimental process, follow the correct operating procedures to avoid equipment damage or inaccurate test results caused by misoperation. Especially in adjusting angles, setting parameters, and other aspects, it is necessary to strictly follow the instructions for operation.

5. Daily maintenance and upkeep

-Regularly inspect and maintain equipment, including cleaning, lubrication, tightening screws, etc., to ensure the normal operation and service life of the equipment. At the same time, pay attention to the requirements of the storage environment and avoid damage to the equipment caused by factors such as humidity and high temperature.