1. It has parameter memory and call recovery functions to protect against data loss due to power outages and crashes;

2. Adopting a domestic streamlined circular arc design, the shell is made of cold-rolled steel plate, the surface is electrostatically sprayed, and the working cavity is made of mirror stainless steel material;

3. Microcomputer intelligent control, LCD display controls temperature, time, and over temperature alarm function;

4. The exterior is coated with baking paint and matte coating to avoid light radiation, the inner lining is mirror stainless steel, and the partition can be adjusted freely;

5. Airflow and enhance convective circulation to ensure the fluidity and temperature uniformity of each layer of air;

6. The observation window adopts a double door design: the double door can be opened to observe the cultivation items inside the cavity, and can be closed when not in use;

7. Adopting compressor and circulating air duct, fluorine free refrigerant, environmentally friendly, and energy-saving;

8. Integrated refrigeration system, multi-layer protection, safe operation and effective self calibration, using non consumable unconventional automated frost to avoid temperature impact and continuous long-term use of equipment.

Intelligent mold incubator manufacturerInstructions for use

Turn the power switch to "1", the power indicator light will turn on, and there will be a digital display on the temperature controller.

Temperature setting: When the required temperature inside the box is the same as the set temperature, it does not need to be set. Otherwise, it needs to be set. First, press the function key "SET" on the temperature controller to enter the temperature setting state. The SV setting display will flash. Then, press the shift key "<" in conjunction with the plus key "△" or minus key "▽". After the setting is complete, press "SET" to confirm.

Whether the refrigeration system is working depends on the set temperature and ambient temperature. When the set temperature is about 3 ℃ higher than the ambient temperature, the refrigeration switch automatically closes and the refrigeration system does not work. On the contrary, the refrigeration switch will automatically turn on and the refrigeration system will work.

After the temperature setting is completed, all data will be saved for a long time. At this time, the incubator enters the heating or cooling state. When the temperature inside the incubator approaches the set temperature, the proportional heating indicator light flashes on and off repeatedly to control the constant temperature state.

Humidity setting: To control the humidity inside the box, first remove the drain plug on the bottom of the box and drain the remaining water in the water tank to prevent overflow. Then open the drawer and fill the spare water tank with 3/4 clean water. When the displayed temperature is close to the set temperature, turn the humidity switch to "1", and the temperature controller will display a number.