Operation method of rapid moisture analyzer

During normal testing, the Beidou Satellite Rapid Moisture Analyzer only needs to insert the sensor into the sample, turn on the power switch, and the test value will be displayed on the LCD monitor

A simple user of an oil product:

Whether on site or in the laboratory, first mix the oil and water evenly, then insert the sensor, and turn on the power switch in the upper left corner of the instrument. After a few seconds, the display will show the test results. Turn off the power after reading. About need10second

Multi table classification test user:

Open the instrument and first observe the top right corner“C#”Is the label the calibration table for the oil type you want to test? Replace the calibration table for the oil type you want to test with the current one, and then perform the above test. Please refer to the method for changing the calibration table《HBD5mInstructions for Use of Moisture Tester1.2Article)

Preparation before use

For the first use, the test data should be checked for accuracy. If it is not accurate enough, it must be recalibrated with user samples. For calibration concepts and methods, please refer to《HBD5mMoisture Tester User Manual2Festival.

This instrument is manufactured before leaving the factory,The Beidou Industrial Chemistry Research Institute strives to conduct preliminary calibration based on the same samples as the users. However, due to differences in samples and standard methods, sometimes it may not be consistent with the user's on-site testing. But through user recalibration, the technical specifications can be achieved.