Zero gas generator with built-in air source

NegotiableUpdate on 12/29

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The zero gas generator is equipped with an air source QP-Plus-AL5P $r $n, which is small in size, light in weight, and can replace high-pressure hydrocarbon removal gas cylinders without the need for transportation. Easy to operate and highly automated, connect the air source, turn on the power switch, and wait for the catalytic temperature to rise to the set temperature to continuously generate zero level air.

Product Details

Zero gas generator with built-in air sourceCharacteristics of QP Plus AL5P：

1Small in size and light in weight, it can replace high-pressure hydrocarbon gas cylinders without the need for transportation.

2Easy to operate, high degree of automation, connect the air source, turn on the power switch and wait for the catalytic temperature to rise to the set temperature It can continuously generate zero level air.

3Reliable safety performance, with two levels of ultra-high temperature protection inside,superHigh temperature causes power outage.

4internally equipped withmanylevelDon't be precisefilterdevice，Can ensureThe air entering the catalytic chamber is dry and clean,No oil, eliminateHydrocarbon removal airqiSecondary pollution.

5All internal air circuits are adopted316 stainless steel inner and outer clean pipes.

6The use of stainless steel drying tubes overcomes the damage caused by aging and eliminates the risk of wear and damage caused by disassembly.

Equipped with an exhaust valve, there is no need to disassemble the hydrogen outlet to release pressure when replacing the desiccant. Simply open the exhaust valve, which is convenient and fast.

Zero gas generator with built-in air sourceQP-Plus-AL5P

parameter

Instrument model	QP-Plus-AL5P
maximumoutput traffic L/min	5L/min
Output zero gas hydrocarbon content	<0.1ppm
output pressure	0-0.5Mpa (factory set 0.4 Mpa)
Export specifications	M8 × 1 aperture with a diameter of 3.3
drying method	Adsorption drying/Silicone gel
Quality requirements for air sources	built-in
Air source pressure requirements	built-in
Requirements for air source flow rate	built-in
Air source inlet specifications	built-in
working power supply	220V/50HZ
environmental conditions	Environmental temperatureDegree:035℃ phase to wet degree ：≤85％ No large amount of dust and corrosive gases, well ventilatedNo direct sunlight
maximum power	700W
ruler inch: LongX Width x Height mm	550×375×425mm
heavy quantity	31KG