Ultrasonic Atomization Thermal Decomposition Furnace OTF-1200X-PGEP

• Atomization device: equipped with a 2.4MHz ultrasonic atomizer, it can atomize liquid into liquid particles and then introduce them into a tube furnace. The ultrasonic atomizer is connected to a stainless steel liquid collection tank to ensure that the liquid that has not been atomized does not enter the tube furnace.
• Heating section (tube furnace): The maximum temperature of the tube furnace can reach 1200 ℃.
• Nano powder collection: the diameter of the collection tube is 50mm, and the voltage is 30KV, which can effectively collect the nano particles brought by the flowing gas

Working voltage&power

• single-phase, 220V AC,50/60 Hz
• Maximum power 3KW

• Continuous operating temperature: 1100 ℃
• Maximum operating temperature: 1200 ℃ (<2hr)

• ≤20℃/min

• Fe-Cr-Al Alloy doped by Mo， Surface coated with zirconia coating

• Heating zone: 400mm
• Constant temperature zone: 140mm (± 1 ℃)

• Can set up 30 temperature rise and fall programs, with overheating and disconnection protection
• The temperature control accuracy is:+/- 1ºC

• Using high-purity quartz tube

Sealing flange&interface

• The left sealing flange is installed with a Φ 6.35mm armor port, stainless steel needle valve, and machine pressure gauge
• A quartz tube with a size of Φ 6.35 × 425mm is inserted into the furnace tube, which can introduce mist particles into the heating zone
• The right end is a KF series quick connect flange, connected to the electrostatic collector

• 220VAC, 2.4MHz ultrasonic machine
• The liquid tank is coated with fluoride and sealed with a fluorine rubber sealing ring
• The power of the ultrasonic device can be set to 0-100%, increasing by 5% each time
• 316 stainless steel tee with 1/4 inch adapter for introducing carrier gas

• Equipped with a mass flow meter (the incoming gas flow rate should be less than 100sccm to protect the furnace tube)

• Made of 316 stainless steel, with a capacity of 150ml
• There are 2 stainless steel needle valves installed on top, with a Φ 6.35mm card sleeve joint
• The lid on the tank is connected with a quick KF clamp, making it easy to open the lid and clean the inside of the tank

• Input: 208~240VAC single-phase, maximum power 15W
• Digital display of voltage and current values, maximum output voltage is 30KV, output current voltage can be set
• Constant current/constant voltage operation mode
• Equipped with arc protection circuit

• The negative electrode plate and positive electrode tube are installed in a quartz tube
• Using KF series quick connect flanges to connect with corundum furnace tubes

About 250kg

One year warranty period (excluding consumables such as furnace tubes, silicone O-rings, and heating elements)

• CE certification
• All electrical components (>24V) are certified by UL/MET/CSA
• If the customer incurs certification fees, our company guarantees that a single device will pass the German TUV certification or CAS certification

precautions

• The pressure inside the quartz furnace tube cannot exceed 0.02 MPa (relative atmospheric pressure)
• Pressure reducing valve must be installed on the gas cylinder (can be purchased from our company)
• The intake flow rate should be less than 100sccm

Delicate Structural Control of Si−SiOx−C Composite via High-Speed Spray Pyrolysis for Li-Ion Battery Anodes