Tool test oil temperature control unit suitable for injection molding machines

Tool test oil temperature control unit suitable for injection molding machines

Tool Test Made in Germany, in stock

Tool Temp Temperature Control Unit TT-168 E

High performance temperature control unit, suitable for demanding injection molding machines

Application scope:

Mold with a maximum water temperature of 90 ° C and a maximum weight of 1200 kilograms

Mold using oil with a maximum temperature of 150 ° C and a maximum weight of 600 kilograms

-Equipped with electronic flow control, suitable for water and oil, as well as leak sealing operations

Standard configuration:

-Digital traffic display and minimum traffic.

-Automatic temperature monitoring. If the effective temperature deviates, an alarm will be triggered.

-An unsealed pump made of bronze. The pressure is displayed on the pressure gauge.

-Automatically optimize the temperature controller to display the set temperature and actual temperature digitally. The temperature is displayed in increments of 1/10 ° C. Can be converted from ° C to ° F.

-A conversion switch used for mold temperature control. By using an external temperature sensor, the temperature can be directly measured on the mold. Temperature can be directly measured on the mold.

-Automatically clear the mold.

-Leak sealing device - can be used for pressure or suction operations. If the mold leaks, the medium will not leak from the mold, and the work can continue smoothly.

-Automatic water injection or manual oil injection.

-Time limited water addition - prevent uncontrolled water addition in case of hose failure. Prevent uncontrolled water addition in case of hose malfunction.

-Scale free heat exchanger.

-The equipment is corrosion-resistant and has a long service life.

-All parts in contact with water are made of stainless steel or bronze.

-Ladder circuit heater - switchable

-Heater with step switch - can be converted from a 6 kW oil heater to a 12 kW water heater.

-Safety device:

-The pre alarm shows that the water level is too low. But the device can still continue to operate. If the water level is reached, the device will shut down.

-Independent mechanical safety thermostat and electronic temperature limiter.

-Main switch, circuit breaker, control transformer, and motor protection switch.

-The horn serves as a malfunction indicator light. The liquid level alarm uses continuous sound, and all other fault information uses intermittent sound.

-All faults are also visually displayed.

-Handle and wheels.

Technical data of TT-168 E thermostat:

Temperature range: maximum water content of 90 ° C, maximum oil content of 150 ° C

Temperature control: automatic optimization

Electronic microprocessor controller MP-888 with digital display of set and actual values. Automatic temperature monitoring.

Flow control: Electronic control, digital display and automatic monitoring of minimum flow.

Heating power (water): 12 kW (3/9/12 level switching)

Heating capacity (oil): 6 kW (step switch 3/3)

Cooling capacity: 45 kW (at 90 ° C)

Pump output power: motor 0.75 kW, maximum pressure operation 4.5 bar/maximum 75 liters/minute,

Vacuum degree during inhalation operation up to 8 mWS

Filling capacity: minimum 16 liters, maximum 20 liters

Connect the circulating medium 1/2 'BS internal thread

Cooling water 3/8 'BS external thread, inlet with water filter

Water filter 3/8 'BS internal thread

Size Length: 710 x Width: 325 x Height: 785

Millimeters, including casters and handles

Weight: Approximately 67 kilograms unloaded

Color: Silver Grey RAL 7

Tool test oil temperature control unit suitable for injection molding machines