Static load seat belt tensile test rubber dummy

1、 Overview of Rubber Dummies for Static Load Seat Belt Tensile Testing:

1. According to national standards, the fall suspension safety belt should be worn on the simulated dummy. 2. Connect the lifting device hook on the upper part of the test stand to the dummy's No. 1 lifting ring. After lifting to a certain height, connect the sensor hook to the dummy's seat belt buckle. At the same time, thread the flat lifting strap through the lifting ring numbered "1". 3. Complete the test according to the steps in the product manual for the overall dynamic load and overall static load of the seat belt. Static load connection of the safety belt as a whole: 1. During the safety belt test for pole work, the lifting rings numbered "5" and "6" are fixed to the corresponding lifting rings on the base of the test stand through a U-shaped release buckle. 2. During the area restriction seat belt test, the lifting rings numbered "2", "3", and "7" are fixed to the corresponding lifting rings on the test stand base through a U-shaped release buckle. 3. During the fall suspension safety belt test, fix the lifting ring with serial number "4" to the middle lifting ring of the test stand base using the U-shaped release buckle and steel wire rope. 4. The specific test steps can be found in the product instructions for the overall dynamic load and overall static load of the seat belt.

2、 Usage method
First, label each part with a serial number for easy explanation.
1. Head suspension ring,
2. Front chest suspension ring
3. Front chest suspension ring
4. Mid leg suspension ring
5. Back suspension ring,
6. Hip rings,
7. Leg bottom suspension ring safety belt overall dynamic load connection

3、 Static load seat belt tensile test rubber dummy product usage:

Seat belts are used to simulate mannequins for various performance tensile tests of seat belts, including dynamic load and overall static load tests that comply with the new national standards. The seat belt is used to simulate a dummy and is the main testing accessory of the seat belt testing system

4、 Attention:



1. The simulated dummy is made of high-strength special material, and after the experiment is completed, the dummy will be placed in a safe indoor location.

2. During the experiment, once the simulated dummy leaves the ground or the force value is displayed in the static test, the tester must stay at least 1 meter away from the frame. Prevent accidental injury caused by falling objects. The operator can only enter the interior of the test stand after the entire experiment is completed.


5、 Technical specifications of rubber dummy for static load seat belt tensile test:



1. The outer surface is made of high-strength special materials



2. Simulated dummy design, by adjusting the center of gravity position, avoids the dummy from deviating or tilting due to center of gravity issues during the testing process


3. The mass of a conventional simulated dummy is (100 ± 0.5) kg. Special specifications can be customized