Stainless steel Y-shaped filter

Stainless steel Y-shaped filterIt is Y-shaped, with one end allowing water and other fluids to pass through, and the other end settling waste and impurities. It is usually installed at the inlet of pressure reducing valves, relief valves, water level valves, or other equipment to remove impurities from the water and protect the normal operation of valves and equipment. The water to be treated by the filter enters the body through the inlet, and impurities in the water deposit on the stainless steel filter screen, resulting in a pressure difference. By monitoring the pressure difference between the inlet and outlet through a differential pressure switch, when the pressure difference reaches the set value, the electronic controller sends signals to the hydraulic control valve and the driving motor, triggering the following actions: the motor drives the brush to rotate, cleaning the filter element, and at the same time, the control valve opens for sewage discharge. The entire cleaning process only lasts for a few tens of seconds. When the cleaning is completed, the control valve is closed, the motor stops rotating, and the system returns to its initial state, starting the next filtration process. After the installation of the equipment, technicians will debug it, set the filtration time and cleaning conversion time, and the water to be treated will enter the body through the inlet, and the filter will start working normally.

Stainless steel Y-shaped filterProduct Categories:

1. Air filters clean polluted air to the level required for production and daily life, that is, to achieve a certain degree of cleanliness.

2. Liquid filters clean contaminated liquids to the required level for production and daily life, that is, to achieve a certain degree of cleanliness.

3. Network filters are set to block junk information and ensure that the information appearing on the computer screen meets the requirements as much as possible. The principle of co absorption separates light of different colors.

4. A light filter that absorbs some unwanted light. The above mentioned should be a mesh filter. In fact, there are many types of filters, such as laminated filters, sand filters, carbon filters, etc. The main principle is to use the pore size of the filter medium to intercept substances smaller than the pore size of the medium. Of course, some filter media also have special effects such as adsorption. Most filters are not that troublesome to backwash, as long as clean water is introduced from one end of the filtered water into the medium in the backwash filter, a good backwashing effect can be achieved. This type of valve should generally be installed horizontally in pipelines.