Stack testing workstation

NegotiableUpdate on 12/12

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The fuel cell testing platform mainly consists of fuel cell stack, cell support structure, flow control system, temperature control system, measurement and control system, and ancillary equipment.

Product Details

a. Electronic load module
-50-200kW (renewable or load type)
-1000A,1500A
-400V,600V,800V
b. Floor standing chassis
-Assemble the box
-Including all necessary hardware and connection accessories
-Keyboard and monitor stand
-Power supply: three-phase 220VAC or 380VAC, Max200A
-1500(W)×3300(D)×2000(H)mm
c. Mass flow controller
-阳极: H2,N2, Max2000,4000 SLPM
-Cathode: Air, N2, Max600012000 SLPM
d. Humidifier bottle device
-Direct injection humidification type
-Temperature control
-Heating chamber and pressure pump system
-Wet and bypass modes
e. Automatic water injection
-Deionized water is automatically injected into the humidifier
f. Heating and cooling water circulation of fuel cell stack
-Pool 100L
-Heating (up to 95 ℃) and cooling system
-Automatic control of circulating flow rate
-Monitoring of water conductivity
g. Deionized water filtration system
-Deionization filtration system
-Automated production
h. Automatic back pressure control and detection
-Max3.5bar control
-Pressure ratio control
-Low pressure drop of 0-2kPa at Max flow rate
-Differential pressure control
-Monitoring of inlet and outlet gas (H2, air) pressure of fuel cell stack
i. Preheater (online heater)
-Flexible SUS stainless steel tube, anode 1.5 ', cathode 2'
-Direct gas temperature control
j. Water trap
-Automatic discharge of condensate water
-Heat exchange and cooling water
k. Operating software
-Based on LabVIEW software
-Various fuel cell operation functions
-Real time data display and data acquisition card DAQ
-Automatic protocol testing
-Process tracking (load tracking)
-Customer customization

Optional items
1. Single cell voltage monitoring
-± 5V/individual battery
-Single cell battery channel selection
2. Single channel or multi-channel AC impedance testing system
-Load combination type, high-frequency resistor HFR combined with IV test
-Frequency range 10mHz~10kHz
-Combination of operating software and fuel cell software
(HFR, IR resistance, Ohmic resistance, AC impedance EIS)

-Multi channel