Soil organic matter analysis sampling

Soil organic matter analysis samplingVolatile organic matter soil sampler, organic matter mud sampler, soil sampler

NameSoil organic matter analysis samplingVolatile organic matter soil sampler, organic matter mud sampler, soil sampler

Model: DXTR-YJW

Supplier: Xiamen Dengxun Instrument Equipment Co., Ltd

1、 Product Introduction

The soil organic matter sampler is mainly used for collecting organic matter samples in soil for subsequent analysis.

Soil samples are directly collected into stainless steel sample tubes and sealed with stainless steel plugs on both sides.

The soil sample can also be transferred to a sample bottle for storage.

If measuring volatile organic compounds in soil, the collection of soil samples must meet the following requirements:

1. Avoid contact between samples and air during sampling and transportation;

2. It is best to maintain the soil in its original state;

3. Avoid contact between soil samples and organic synthetic materials;

2、 DXTR-YJW product specifications:

1. Specifications: Sampling tube diameter 38mm, length 241mm, sampling length 20cm. Standard configuration sampling depth 2m.

2. Standard configuration:

1 T-shaped handle

Strike one handle

1 energy absorbing hammer

One sampling tube holder

5 stainless steel sampling tubes

5 stainless steel plugs

5 stainless steel sheets

10 sealing covers

1 heart-shaped loam drill bit

Two 100cm extension rods

1 50cm extension pole

1 sample extractor

1 scraper

Two wrenches

1 steel tape measure

1 pair of gloves

Aluminum box packaging.

Note: The above configuration is for reference only and may be changed according to the actual situation. The final version shall prevail.

3、 Operation method:

1. Install the sampling tube and sampling tube holder.

2. Connect the striking handle, extension rod, drill bit, and threaded connection.

3. Select sampling points.

4. Place the drill bit at the sampling point, one person holds the striking handle with both hands, and the other person uses a rubber hammer to strike the handle, and the drill bit enters the soil.

5. After reaching the sampling depth, lift the drill bit and the soil will be retained inside the drill bit. Remove the sampling tube holder, plug the end connected to the holder with a stainless steel plug, plug the other end with a stainless steel sheet, and seal both ends with sealing caps for storage.

6. Connect the second sampling tube to the sampling tube holder, complete the second sampling, repeat the above operation, and continue sampling.

7. When removing soil, a sample extractor can be used to push the soil out.