SMC standard cylinder structure and classification

NegotiableUpdate on 05/23

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

SMC standard cylinder structure and classification $r $n Double acting cylinders can also be divided into single piston rod type and double piston rod type (see Figure 3-7 below). The compression area on both sides of the piston of the double piston rod type cylinder is equal, and the motion stroke and output force on both sides are equal. Can be used on devices for long travel workbenches. The piston rod is fixed at both ends, and the cylinder barrel of the cylinder moves with the worktable, enhancing rigidity and good guidance.

Product Details

SMC standard cylinder structure and classification

Travel adjustment markers-Nothing

Dual trip marking-No double trip markings

● Lightweight: 65% reduction in weight (39.1kg → 13.4kg)

● High rigidity: allows for a maximum lateral load of 900N

● Improved homework performance: The piping ports are concentrated in the axial direction, increasing the degree of freedom in piping

(Axial centralized piping type)

The standard type (single pole, double pole) has been added with a diameter of 320

Added long-range type (Φ 180~Φ 320)

The piston rod usually can only withstand axial loads. Avoid applying lateral and eccentric loads on the piston rod. When there is a lateral load, a guide device should be added to the piston rod, or a guide rod cylinder should be selected

When installing a fixed cylinder, the axis of the load and piston rod should be consistent. When installing earring type and ear shaft type cylinders, the swing of the cylinder and the swing of the load should be in the same plane. Otherwise, the seal may be worn off, causing air leakage and reducing the service life of the cylinder; If it is severe, the cylinder will not move. Sometimes, the cylinder may also experience impact actions, which may cause damage to the body and equipment.

In places with high dust, water droplets, and oil droplets, the pole side should be equipped with a telescopic protective cover. In situations where telescopic protective covers cannot be used, cylinders with strong dust seals or waterproof cylinders should be selected.

If the ambient temperature and medium temperature of the cylinder exceed -10~60 ℃ when equipped with a magnetic switch, anti freezing or heat-resistant measures should be taken.

double-actingNothingThe cylinder barrel is integrated with the rodless cylinder head, and the rod cover is fixed with an elastic retaining ring. Small size, light weight, thin, small installation space, easy to install. Large bore and long stroke, lateral load resistant type with cushion cushioning. In addition, CQS can also have long trips.

double-actingCushion cushionThe cylinder body is rectangular and can be installed in various ways. High installation accuracy. The installation space is small.

It is to verify whether there is a lateral load exceeding the bearing capacity of the piston rod, and the specific verification method,

Built in magnetic ring-No built-in magnetic ring

Installation methodFRod side flange type

bore140Cylinder diameter 140mm

Types of threaded connections-Rc

cylinder stroke125Cylinder stroke 125mm

Cylinder tracking number-Without protective cover

SMC standard cylinder structure and classification