Rubber airbag internal water pressure testing machine

Xinghuo Company currently has an area of over 10000 square meters, and its office is located in the western new city of Jinan, with convenient transportation; The company has administrative department, marketing department, production department, research and development department, after-sales department, etc; We have a group of highly educated, high-quality, and experienced R&D, production, and sales company products that continuously meet the domestic market. At the same time, some of our products are exported to Southeast Asia, South Asia, the Americas, the Middle East, Africa, Oceania, Central and Northern Europe, the European Union, and other parts of the world, and we have established good cooperative relationships with foreign counterparts. After sales service personnel, the company has a high degree of youthfulness, among which97%Personnel with a college degree or above;

Rubber airbag internal water pressure testing machineProduct NameRubber airbag internal water pressure testing machine

The basic principle is to calibrate the sample by outputting high pressure from the booster pump based on the different pressures of the sample.

Test pressure 0.5~10M Pa

Control pressure accuracy test:+2% of the upper limit and -1% of the lower limit of the pressure value

Computer control method for water pressure control of experimental medium

Operation method: Computer operation

Sample quantity: 1 route

Sample installation method: Thread

Structural composition - Circulating system, pressure control system, workpiece installation device, manual control

Scope of application: Air springs

Test pressure 600Kn

Testing method:

1. Destructive test

Fix the air spring at the standard height and gently bounce towards the air at a rate not exceeding 1.00MPa/min

Inflate the spring with high-pressure water until the airbag is damaged, record the highest water pressure before the airbag is damaged, and use it as the basis for the airbag

Disrupting internal pressure

2. Volume test: First, fill the air spring with water, remove the air inside the air spring, and then remove the air

Adjust the spring to its maximum tension state and ensure a water pressure of 0.5 MPa; Open the air spring from the maximum stretching position

At the beginning, the height did not decrease by 10mm. Based on the flow sensor or measuring cup reading the amount of water discharged, colleagues measured it

Record the maximum outer diameter until the air spring reaches its maximum compression state, and record the remaining water volume

Accumulate.