Original imported MSA20LS model PMI guide rail, supplied by Anang Mall guide rail

Original imported MSA20LS model PMI guide rail, supplied by Anang Mall guide rail

Yintai linear guide railThe structure and characteristics of
1. High positioning accuracy
When using Intime linear guides as linear guides, due to the rolling friction mode of the linear guides, not only does the friction coefficient decrease to 1/50 of sliding guides, but the difference between dynamic and static friction forces also becomes very small. Therefore, when the bed is running, there will be no slipping phenomenon, and the positioning accuracy can reach μ m level.
2. Low wear can maintain accuracy for a long time
Traditional sliding guidance inevitably leads to poor platform motion accuracy due to grease reflux, and insufficient lubrication during motion causes wear on the contact surface of the running track, seriously affecting accuracy. The wear of rolling guidance is very small, so the machine can maintain accuracy for a long time.
3. Suitable for high-speed motion and significantly reduces the required driving horsepower of the machine
due toYintai linear guide railWhen moving, the friction force is very small, and only a small amount of power is needed to make the bed run. Especially when the working mode of the bed is frequent back and forth operation, it can significantly reduce the power loss of the machine. And due to its low heat generated by friction, it can be suitable for high-speed operation.
4. Can withstand loads in all directions simultaneously
due toYintai linear guide railThe special beam structure design can simultaneously withstand loads in the up, down, left, and right directions, unlike sliding guides that can withstand lighter lateral loads in the direction of parallel contact surfaces, which can easily cause poor operating accuracy of the machine.
5. Easy assembly and interchangeability
When assembling, as long as the assembly surface of the guide rail on the milling or grinding table is milled or ground, and the guide rail and slider are fixed to the machine with specific torque according to the recommended steps, the high-precision during processing can be reproduced. Traditional sliding guidance requires scratching the running track, which is both laborious and time-consuming, and once the machine accuracy is poor, it must be scratched again. Yintai linear guides have interchangeability, allowing for the replacement of sliders, guides, or even linear guide assemblies separately, allowing the machine to regain high-precision guidance.