Micro deuterium tungsten halogen lamp light source

Micro deuterium-tungsten-halogen lamp

DT-MINI-2andDT-MINI-2-GSdeuterium-The tungsten halogen combination light source integrates a deuterium lamp light source for ultraviolet light and a visible light source/Tungsten light source for near-infrared light, capable of providing ultraviolet light in one optical path/it is thus clear that/Continuous output spectrum in the near-infrared band.This combination of light sources can generate~200-1100 nm

Stable output spectrum.0.5mm

Aperture: Stronger output DT-MINI is our first attempt to enter a combination and universal UV-NIR light source, which is still a good choice for a range of applications and measurements to this day. The advantage of DT-MINI-2 and DT-mini-2-GS is that the bulb adopts a narrow aperture of 0.5mm. It can generate a uniformly focused light beam connected to the optical fiber.

Switch modelDT-MINI-2-GSdeuterium-The halogen tungsten lamp also uses a strip0.5mmA narrow slit light bulb. Its feature is a shutter that blocks the light path, either manually orTTL

The signal can control this shutter. Two independent switches control the deuterium lamp and the tungsten halogen lamp respectively.

A series of enhanced modelsThere are also a series of enhancementsDT-MINI-series

The lamp. These light sources can be connected to the channels of the spectrometer and installed together with other accessories in various chassis.

technical specificationsstandard

DT-MINI-2 DT-MINI-2-GSsize

: 153.4 mm x 104.9 mm x 40.9mm 140 mm x 50 mm x 125 mm

weight: 330 g 475 g

wavelength range: 200-410 nm (deuterium);

360-2000 nm (tungsten halogen) 200-410nm (deuterium); 360-2000 nm (tungsten halogen)

energy consumption: 350 mA @ 12 VDC 350 mA @ 12 VDCoutput: 3.8 watts (deuterium); one point twowatts (tungsten halogen) 3.8 watts(deuterium); 1.2 watts (tungsten halogen)stability4: 0.3% 30After minutes of preheating, peak-Peak stability(exceedhour4) 0.3%thirty

After minutes of preheating, peak-

Peak stability(

exceedhour)stability time: 10 minutes (deuterium); oneminute (tungsten halogen) 10 minutes

(deuterium); 1 minute (tungsten halogen)lamp life

: ~1500 hours (deuterium);1500 hours (tungsten halogen) ~1500hours (deuterium); 1500 hours (tungsten halogen)delay time

: <2.0 seconds (

It takes longer when the temperature is low) <2.0seconds (It takes longer when the temperature is low200)connector: SMA 905 SMA 905USB-DTdeuterium

-

Tungsten halogen lampThe most versatile light sourceUSB-DTDeuterium type-The halogen tungsten combination light source is a compact light source with a size only the size of a deck of cards, which can provide stable wideband output with a wavelength range of～2000nm.USB-DTIt is the most powerful ultraviolet visible light source developed for ocean optics, and users can use software to control its functions and install various methods for measurement.

Software ControlWhen

USB-DTType light source and

USB4000Type spectrometer or

HR4000，

HR2000+perhaps

QE65000Type spectrometer andWhen used together with the data expansion box, users can control the following functions of the light source through software:

•Adjust the brightness of the light bulb•Use an internal shutter to cut off the light path•Independently control the on-off shutter of each light source•Use low-power shutdown mode•Save settings in memorygiveUSBShared use of series spectrometersUSB-DT

The type of light source can be set in different ways, which can be achieved throughUSB-ADP-DT2

The connector is connected toUSB4000

Above the spectrometer, as shown in the image on the right.USB-ADP-DT2
Connectors need to be purchased separately. due toUSB-DT
Type light source is stacked withUSB2000
The spectrometer cannot be connected without fiber optic connections like a direct attached light source, so fiber optic connections are still required,And one
5VTransformer (including).
USB-DTspectral output
USB-DTtechnical specifications
size: 81 mm x 90 mm x 37 mm