MOOG servo valve G761-3026B Suzhou*

MOOG servo valve G761-3026B Suzhou*

For the dynamic water level (the water level when the submersible pump and water pipe are lowered and the pump is turned on continuously to pump water until the water level no longer drops), due to the fact that the water pipe is generally connected by multiple flanges and has a small gap with the wellbore, the rope cannot be lowered or lifted, so it cannot be measured. In addition, water pipes and well walls are often damp, which makes it difficult to reflect the true water level at the soaked positions on the rope. If you want to measure the rate of water level drop after the pump is turned on, this simple method is even more powerless. For deep wells, the above issues are even more prominent.

Therefore, to solve the above problems, Gongcaiwang recommends the intelligent water level over limit monitoring sensor - CS-iWM-03 to measure the water level changes in the groundwater well.

The intelligent water level over limit monitoring sensor is installed at the wellhead of the drainage well to monitor in real time whether the water level of the drainage well exceeds the set water level height. When it exceeds the water level line height, the status of the float level switch changes. The status quantity is collected and processed by the MCU, and an alarm message is sent through GPRS. At the same time, when the water level height returns to normal, a normal signal is sent again to the monitoring center for timely alarm processing and assistance. The intelligent water level over limit alarm uses a float level switch to determine whether the water level exceeds the set water level height, and sends corresponding alarm information through the sensor terminal.

Secondly, in addition to the above-mentioned sensors, the photoelectric liquid level sensor can detect the water level in the well without opening the well cover. At the same time, it can achieve real-time information transmission and is easy to operate. It is recommended to use the low-cost photoelectric liquid level sensor/photoelectric liquid level switch LLC200A3SH from the UK SST.

The photoelectric liquid level sensor/photoelectric liquid level switch - LLC200A3SH provides single point liquid level detection, specially designed for large-scale OEM customers. The sensor contains an infrared emission source and a detector, with precise installation position to ensure good optical coupling between the two in air. When the conical end of the sensor is immersed in liquid, infrared light will transmit out of the conical surface, and the intensity of light reaching the detector will weaken. Suitable for leak detection, oil level monitoring, water level control, automatic beverage machines, food and beverage machines, water pumps, household appliances and other fields.

MOOG servo valve G761-3026B Suzhou*