-
E-mail
sales@lingyukeji.com
-
Phone
15320105518|18920902093|18920413023
-
Address
Workshop on the right side of the first floor of the scientific research building in Zhonglian Industrial Park, Xiqing District, Tianjin City
Product Categories
Tianjin Lingyu Technology Co., Ltd
LPS-S3 diaphragm pressure switch
NegotiableUpdate on 07/24
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
Suitable for measuring the pressure of liquids, gases, or vapors, high and low limit alarms can be achieved by comparing the measured pressure value with the set value. The output signal is a passive dry contact signal (SPDT). It is commonly used for: 1. Air compressor start stop control; 2. Pipeline pressure high and low limit alarm, interlock start stop pump, etc. The pressure switch directly outputs the switch signal, and the function can achieve pressure transmitter+PLC/control instrument output switch control. The structure is simple, highlighting its advantages in on-site control in small-scale control. This product has the following features: ● Fully welded diaphragm, zero leakage ● Mechanical principle, no need for power supply ● High quality micro switch, small dead zone ● Diverse process interfaces, flange threads can be customized ● SPDT and DPDT switch nodes
Product Details
product overview Product overview
The LPS-S3 series diaphragm pressure switch adopts a fully welded stainless steel diaphragm, which uses mechanical deformation to control the target pressure in the automation control system. This method is the simplest and most reliable pressure protection measure. The entire design is simple and easy to use, with few fault points, and can effectively prevent liquid leakage and misoperation; Based on the above advantages, this series of pressure switches is widely used in various industries such as petroleum, chemical, metallurgical, power, sugar, pharmaceutical, etc. that require pressure control. This series of switches SPDT is suitable for single point control, while DPDT is suitable for dual point synchronous control or dual point asynchronous control.
measuring principle principle
Diaphragm pressure switch is a mechanical pressure switch that uses the mechanical deformation of the diaphragm to achieve the function of controlling contact closure and disconnection. When the pressure of the measuring medium changes, the diaphragm will produce corresponding displacement. The displacement of the diaphragm is transmitted to the micro switch through the transmission component. When the displacement stroke reaches the set value, the micro switch will be pushed, causing the contacts of the micro switch to close or open as a state variable. Adjustable pressure switches can control pressure within a fixed value or range by adjusting the stroke relationship between transmission components and micro switch contacts, in order to achieve control objectives.
performance index TECHNICAL PARAMETERS
Measurement medium: gas or liquid (in highly corrosive environments, communication is required)
Shell material: die cast aluminum, epoxy resin coating, outer cover with sealing gasket
NEMA protection level: meets NEMA 4X requirements
Set value accuracy: ± 0.5%
Repeatability accuracy:<1%
Pressure interface: standard 1/2NPTF internal thread, M20 * 1.5 external thread; Special interfaces can be customized
Electrical interface: M20 * 1.5 internal thread; Special interfaces can be customized
Switch output: a single pole double throw (normally open+normally closed) output;
Environmental temperature: -40 ℃ to+70 ℃
Environmental humidity: 5% to 95%
Cycle life: 1 million cycles
Protection level: IP67
Explosion proof rating: Exde IIC T6 Gb
Dust explosion-proof: ExtD A21 IP66 T80 ℃;
Contact capacity: Conventional type: 380V, 15A; Explosion proof type: 380VAC, 5A;
External dimensions APPEARANCE OF SIZE
The materials are being prepared ..
INSTALLATION REQUIREMENTS INSTALLATION
The materials are being prepared ..
