Imported Panasonic TC-190H52 (N200)

Imported Panasonic TC-190H52 (N200)Imported Panasonic TC-190H52 (N200)

Panasonic battery features: 1. Simple maintenance. During charging, most of the oxygen generated inside the battery is absorbed by the electrode plates and reduced to electrolyte, with little reduction in electrolyte. The electrolyte with high liquid holding capacity is absorbed in a special separator and remains in a non flowing state, so it can be used even if it falls down. (Cannot be used when falling over 90 degrees) 3 Safety performance: Due to overcharging operation errors, excessive gas can be released to prevent battery rupture. 4. Use special lead-acid alloy to produce grids for small self discharge electrodes, controlling self discharge to a small level. The grid of the battery with long lifespan and good economy is made of special lead calcium alloy with good corrosion resistance. At the same time, a special separator is used to retain the electrolyte, and the active material on the positive plate is tightly pressed to prevent detachment. Therefore, it is a battery with long lifespan and economy. Due to its low internal resistance, it has good discharge characteristics for high currents. After deep discharge, it has excellent recovery ability. In case of long-term discharge, as long as it is fully charged, there is basically no decrease in capacity, and it can be quickly restored. No free acid, the battery can be safely inverted at 90 ° C, and has an extremely low electrolyte ratio. Application scope: Communication equipment, uninterruptible power supply, emergency lights, electronic systems, alarm systems, solar energy systems, toy control equipment

Matsushita Pure Imported Starting Battery Part Model Parameters

Precautions for battery installation:
1. The battery should be kept away from heat sources and places where sparks are easily generated, and its safe distance should be greater than 0.5m.
2. The battery should be kept away from direct sunlight and should not be placed in environments with high levels of radioactivity, infrared radiation, ultraviolet radiation, organic solvent gases, and corrosive gases.
The installation ground should have sufficient load-bearing capacity.
Due to the high voltage of battery components, there is a risk of electric shock. Therefore, insulated tools should be used when loading and unloading conductive connecting strips, and insulated gloves, aprons, and protective goggles should be worn when installing or handling batteries. During the installation and transportation of batteries, only non-metallic lifting straps can be used, and steel wire ropes cannot be used. 5. Dirty or loosely connected connection strips can cause battery ignition and even damage to the battery pack. Therefore, during installation, careful inspection and removal of dirt on the connection strips should be carried out, and the connection strips should be tightened.
Batteries of different capacities and performances cannot be interconnected for use. Before installing end connectors and conducting the battery system, the total voltage and positive and negative poles of the battery system should be carefully checked to ensure correct installation.
The battery casing cannot be cleaned with organic solvents, and carbon dioxide fire extinguishers cannot be used to extinguish battery fires. Fire extinguishers such as carbon tetrachloride can be used.
When connecting the battery to the charger or load, the circuit switch should be in the "OFF" position and ensure correct connection: the positive pole of the battery should be connected to the positive pole of the charger, and the negative pole should be connected to the negative pole.