Huainan Aomei Si B1 grade rubber insulation board manufacturer

Huainan Aomei Si B1 grade rubber insulation board manufacturer

Construction method of rubber insulation board:

1. Shake the container before use to make the glue evenly distributed. During actual installation, use a small can of glue to prevent it from evaporating too quickly. If necessary, pour the large can into the small can and seal the can mouth when not in use.

2. Use a short and hard brush to apply a thin and uniform layer of specialized adhesive to the bonding surface at both ends of the material. Baicheng Rubber Insulation Board Factory

3. The natural drying time of specialized adhesive is 310 minutes, and the length of time depends on the grade of the adhesive, the temperature and humidity of the atmosphere. Generally, the following principles should be followed: the higher the ambient temperature, the higher the relative humidity, the lower the medium temperature, and the thicker the material for larger pipe diameters; Exposure time exceeding 20 minutes is invalid.

4. When using, wait for the glue to dry naturally. The correct method for measuring dryness is the 'finger touch method'. Use your fingers to touch the adhesive surface. If the fingers do not stick to the material surface and there is no feeling of sticking to the material surface, you can proceed with bonding. When bonding, simply grip the two surfaces of the adhesive interface tightly for a while.

5. Normally, each kilogram of rubber adhesive can be applied to two square meters of bonding surface.

6. When connecting two materials under pressure, there is no need to wait for the glue to dry. The wet bonding method is used. First, place the materials at the installation site, apply glue to the interface of the materials, adjust the position of the two materials correctly, and soon they will be firmly bonded according to your designed position

Aluminum foil veneer rubber insulation board manufacturers should pay attention to the following points when installing rubber insulation boards:

1. After installation, all tees, elbows, valves, flanges, and other accessories must reach the design thickness.

2. When installing, large pipes should be installed first, followed by small pipes, elbows and tees should be installed first, then straight pipes, and finally valves and flanges.

3. All cuts and joints need to be glued and sealed.

4. Do not apply too much force when bonding with glue, and all interfaces between materials should be bonded under slight compression.

5. The cutting edge of the pipeline should be installed as inconspicuously as possible, and the cutting edges of the two pipes should be staggered from each other.

6. When installing chilled water pipes and refrigeration equipment, the gaps between the two ends of the rubber pipe and the iron pipe need to be coated with glue and bonded together, and the bonding width should not be equal to the thickness of the rubber material.

7. Do not install the machine during use. Do not turn on the device within 36 hours after installation.

Huainan Aomei Si B1 grade rubber insulation board manufacturerFlexible rubber insulation board first

One advantage is that it has excellent toughness, even for some very curved and irregular pipelines, it can be constructed well and is very simple because it can be bent freely without any quality problems.

Another reason for the ease of construction is that the flexible rubber insulation board can be cut freely and bonded in any way during construction, without any additional considerations, which wastes our construction time. After installation, the flexible rubber insulation board is very aesthetically pleasing, without the need for various maintenance or worry about problems. It provides a great post construction experience, bringing convenience to both construction personnel and manufacturers. You can save a lot of worry. If you want to repair the equipment, you can also reuse the rubber insulation board after the repair to save our costs. The introduction of so many simple arguments for the construction of flexible rubber insulation boards can also prove this point.

We are a professional rubber insulation manufacturer, and all workers can carry out excellent construction, which definitely meets the national standards and has won many honors. If you have any requirements for rubber insulation board construction, you can do it at any time to ensure a simple and worry free construction experience for you