Gauss Motor supplies torque sensors directly to Japan KYOWA Republic

NegotiableUpdate on 05/07

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Gauss Motor supplies KYOWA Republic torque sensor $r $nTPS-A-1KNM #177; Used for 1kN #183; m）

Product Details

Gauss Motor supplies torque sensors directly to Japan KYOWA Republic

TPS-A

TPS-A-1KNM ± for 1kN · m)

specification

performance

Rated capacity	± 1 kN · m
rated power	5 V ± 4% (load resistance>5 k Ω)
nonlinear	± RO within 0.3%
lag effect	± RO within 0.3%

Environmental characteristics

Allowable temperature range	-10~70 ° C (non condensing)
Temperature compensation range	-10~60 ° C (non condensing)
The impact of zero point on temperature.	Within 0.03% RO/° C
The impact of output temperature	± within 0.05%/° C

Electrical Characteristics

Amplifier cut-off frequency	500 Hz (cut-off point -3 ± 2 dB amplitude ratio)
signal-to-noise ratio	45 decibels or higher (without rotation)
power supply	DC 10-16V
Current electricity consumption	below 0.5A DC 12V power supply

mechanical properties

Allowable overload	150%
maximum speed	4000 revolutions per minute
Rotating power	4 pulses/rotation (open electrode output cannot detect rotation direction)
protection level	IP40（JIS C 0920）
Allowable bending moment	150 N · m (single sensor)
Allow axle load	800 Newton (non rotating)
moment of inertia	2.6×10-3kg·m2
quality	about 10 kilograms

Sell separately

Coupling: SFH-190S-T010-K-45K - □ K ○ None

Keyway □ is the diameter of the mating hole, ○ is the machining tolerance of the shaft (unmarked: h7, K: k6, M: m6, J: j6, S: 35+0.010~0)

Communication adapter UNI318-1215-AC,
Output line U-15 (1.5 meters, P12-7-BNC connector),
Output line BNC plug -2-core Minomsi clip (please contact us for details), output
Wire U-59 (1.5 meters, BNC connector - BNC connector)

DC 12V: DC power cord P-76 (recommended 12V),
Output line U-15 (1.5 meters, P12-7-BNC connector),
Connect the BNC plug of the output line to a 2cm micro clamp (please contact us for details),
Output line U-59 (1.5 meters, BNC connector - BNC connector)

DC 24V: 24V DC P-80 power cord (used to convert DC 24V power supply to DC 12V),
Output line U-15 (1.5 meters, P12-7-BNC connector),
Connect the BNC plug of the output line to the two pin minoMSI clamp (please contact us for details),
Output line U-59 (1.5 meters, BNC connector)