Gas environmentally friendly single head steam furnace

Detailed introduction: Size (mm): 900 (length) x1050 (width) x810+440 (height) Gas environmentally friendly single head steaming furnace, using high-quality stainless steel plate, national standard angle steel as the skeleton, laser cutting, seamless welding, processing, single head steaming furnace with stainless steel adjustable feet, gas: liquefied petroleum gas/liquefied natural gas

Detailed introduction:

Dimensions (mm): 900 (length) x 1050 (width) x 810+440 (height)
Gas environmentally friendly single head steaming furnace, made of high-quality stainless steel plate, with national standard angle steel as the skeleton, laser cutting, seamless welding, and processing. The single head steaming furnace is equipped with stainless steel adjustable feet. Gas: liquefied petroleum gas/liquefied natural gas; Rated pressure: 2800pa for liquefied petroleum gas/2000pa for natural gas; specific specifications and parameters for single head steaming furnace are as follows:
——Heat load: 42 kilowatts;
——Self induced draft large fire hole environmental protection furnace head, fire tube structure water tank;
——Button power switch, automatic pulse electronic ignition, ion flame monitoring, bidirectional solenoid valve with ignition source;
——Configure a hard water softening device suitable for use in hard water areas;
——Suitable for steaming baskets with a diameter of 550 millimeters;
——Operating noise:<65 dB;
——Carbon monoxide emissions:<0.05%;

——Air inlet/water inlet/drainage outlet: DN20/DN15/DN40;

1、 Installation
1. This product must be connected to a liquefied petroleum gas source using a household pressure reducing valve (JYT-0.6).
2. Connect the tap water pipe with a water pressure of 1.5 Mps or above.
2、 Power on
1. First, turn on the tap water switch and fill the water tray with clean water.
2. Open the petroleum gas source valve.
3. You must first press the ignition button, and then open the gas valve to ignite.
3、 Cleaning
1. After using it every day, please rinse it completely with cold water.
2. If there are many debris around the heat exchange tube that cannot be removed after long-term use, the water in the water tray should be filled to about 70%, boiled, and then sieved with a dense mesh to remove the debris.
4、 Precautions
1. Please do not use the petroleum gas cylinder upside down or sideways.
2. When the weather is cold or used for a long time, do not immerse the oil cylinder in hot water. If necessary, use cold water instead.
3. It should be used in a well ventilated area. If used indoors, please install a powerful ventilation fan to ensure sufficient oxygen supply in the space.
5、 Repair Guide
1. Cannot ignite: Replace the electronic igniter and it can be used.
2. Reduced firepower: Blocked jet nozzle, use a small wire to smooth out the blocked jet nozzle.
For detailed information, please refer to the product manual attached. For other inquiries, please call the manufacturer at 0543-2856122 for similar models of products