Fully automatic closed flash point tester

1. Automation level: Industrial grade ARM 32-bit chip core processor, automatically completes the testing process. Support online monitoring and downloading, easy to use.

Control System: Industrial grade PLC programmable logic controller is used, which has been treated with three anti paint to ensure worry free operation of the instrument. The 7-inch tablet has a touch screen display, and you can complete the experiment according to the screen prompts without training.

3 Operating System: Windows CE embedded operating system, fully Chinese operation interface, page switching at will, simple and convenient operation, automatic printing of results, large capacity storage function, can store tens of thousands of data and curves.

4 Performance: Automatic diagnosis, over temperature alarm and automatic cut-off of heater power supply, alarm prompt function for test completion.

5 Data input/output: RS485 connection standard, can be connected to USB 2.0 interface.

AVSD-102BFully automatic closed flash point testerTechnical Indicators:

1. Power supply: AC220V ± 10% 50Hz

Heating power: 400W

3. Environmental temperature: 10-30 ℃

4. Range: Room temperature~300 ℃

5. Resolution: 0.1 ℃

6. Repeatability: ≤ 2 ℃

7. Reproducibility: ≤± 4 ℃

8. Lifting method: automatic tilt

9. Detection method: With full Chinese operation software prompt function, differential detection, automatic correction of system deviation, equipped with parameter prompts such as experimental date and time

10. Data output: automatic completion of opening, ignition, detection, and printing test data by microcomputer

11. Ignition method: gas flame, forced air cooling

12. Number of experimental cups: single cup

13. Dimensions: 400 * 380 * 300 (height)

14. Weight: 12kg

AVSD-102BFully automatic closed flash point testerInnovative Technology:

1. Copper casting heater: replaces traditional electric furnace wire heating, works without open flames, and does not cause fires. The internal heating wire of the heater is isolated from the air and has a long service life.

2. Silicon nitride ignition head: High temperature resistant silicon nitride ceramic material is used, and the ignition head is inserted into the upper end of the insulating ceramic. This type of ignition head has a fast ignition speed (10 seconds), high ignition temperature (1200 ℃), and long service life. Below the ignition head is the Changming flame source. Next to the ignition head is a temperature sensor. If the flame goes out, the ignition head will automatically ignite the flame; If the Changming flame burns normally, the ignition head will stop working, greatly extending the service life of the ignition head and achieving maintenance free ignition head.