Dead point detector

Product Description:
Automatic control and detection of high-precision mold stamping processes can increase production, compensate for human errors, reduce defect rates, and achieve high-quality automated testing.
characteristic:
1. Single type (SD-401): one host and one output device
2. Dual point (SD-402): Two hosts and two output devices
3. Sensor operation setting distance: 0.8MM to 1.2MM for position (A). Please press the setting switch to display 199 to 0, then move the sensor head iron block to adjust the operation distance from 80 to 120 (i.e. 0.8MM to 1.2MM). After setting, press the setting switch to restore.
4. The operation of setting monitoring values, with a precision setting range of ± 1 ц m~± 99 ц m, is set according to your actual required accuracy during monitoring.
When the punching die starts to move, the first four displayed numbers on this check are the average height test values of the mold (when the punch power switch is turned off); This value will only be recalculated when the sensing line is removed from the sensor and reinserted, etc.
6. OP: It will occur when the sensing line and sensing head break or when the sensing is pulled apart.
7. HL: If the height is too high, the abnormal red light and the high yellow light will light up. (More than 1.2mm away from passing by).
8. LO: If it is too low, the abnormal red light and the low red light will light up. (Distance exceeding 0.8mm).