DMF-Y-50S submerged electromagnetic pulse valve

1DMF-Y-50SSubmerged electromagnetic pulse valveTECHNICAL INDEX

IIIDMF-Y-50SSubmerged electromagnetic pulse valveInstallation method

1、DMF-Y-50SSubmerged electromagnetic pulse valveThe valve body is fixed on the distribution box by first fixing the connecting pipe, then fitting the valve body onto the connecting pipe (lubricated appropriately), and finally fixing it on the distribution box with bolts. For the convenience of installation, our company specializes in producing matching connecting pipes, which are made of aluminum alloy die-casting and have the characteristics of good sealing and easy installation. The outlet of the connecting pipe is a sliding type.

2、DMF-Y-50SSubmerged electromagnetic pulse valveAll during installationOSuitable lubricant should be applied to all sealing rings

3All of themYThe assembly method of type valves is equipped with sealing gaskets, especially“float”The sealing gasket is fixed on the surface of the distribution box using the air pressure inside the distribution box.

4、DMF-Y-50SSubmerged electromagnetic pulse valveIt should be used in conjunction with a pulse jet control device. The submerged electromagnetic pulse valve coil has three pins and is equipped with a dedicated plug, one of which has' 'The symbol represents the grounding pin, and users can decide whether to ground it according to their needs. In general, the voltage is less than36VWhen not grounded, greater than36VThe time should be grounded. ）The other two are coil power pins, which are respectively connected to the terminals corresponding to the sequence of the pulse jet controller and the terminals of the valve common line.

5Submerged electromagnetic pulse valves can be installed using3/4 'perhaps1'Drill holes on the side of the conduit (the number of holes is the same as the number of electromagnetic pulse valves), and thread them0.3mm2~0.5mm2Copper wire ensures a good electrical connection between the electromagnetic pulse valve and the pulse blowing control device, with the blowing width and interval set by the pulse blowing control device.

6The dust collector's air distribution box (including the connecting pipe) is determined by the user, and the capacity of the air distribution box should meet the requirement of providing a stable air source for the electromagnetic pulse valve. The inner wall of the air distribution box should be clean and free of rust and other debris, and the air distribution box should be leak free and comply with relevant safety requirements.

7The applicable temperature for the sealing components of the submerged electromagnetic pulse valve and the air bag and spray connection pipe is-25℃～90℃If high-temperature sealing components are required,Please specify separately when placing an order.