Constant temperature oscillation of cooling water bath

NegotiableUpdate on 07/16

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

When the constant temperature oscillator of the cooling water bath is heated to the desired temperature, the heating will automatically stop and the green indicator light will be on; When the heat inside the test chamber dissipates below the temperature you set, a new round of heating will begin.

Product Details

Technical parameters of constant temperature oscillator for cooling water bath:

1. Power supply: 220V 50Hz

2. Overall power: 1800w

3. Timing range: 0-120 minutes

4. Oscillation frequency: starting -300 revolutions per minute, adjustable

5. Oscillation amplitude: 20mm

6. Constant temperature range: 5-100 ℃ (with refrigeration)

7. Workload: 20kg

Instructions for using the constant temperature oscillator for cooling water bath:

edit

1. Load the test bottle and maintain balance. If it is a dual function model, set the oscillation mode. (For detailed settings, please refer to the diagram below *)

2. Connect the power and set the timer according to the surface scale of the machine. If you need to work for a long time, adjust the timer to the "normally open" position.

3. Turn on the power switch and set the constant temperature:

(1) Place the control switch in the 'Setting' section, and the temperature displayed on the screen will be the set temperature. Adjust the knob to set it to the temperature you need for your work

Degree is sufficient. (The working temperature you set should be higher than the ambient temperature. At this time, the machine starts heating up and the yellow indicator light is on. Otherwise, the machine will not work.)

(2) Place the small switch of the control part on the 'measurement' end, and the temperature displayed on the screen will be the actual temperature of the air inside the test chamber, which will vary with the temperature inside the chamber

The displayed numbers will also change accordingly.

（3）

4. Activate the oscillation device:

(1) Turn on the oscillation switch on the control panel, and the indicator light will turn on.

(2) Adjust the oscillation speed knob to the desired oscillation frequency.

5. Cut off the power after work, and set the speed control knob and temperature control knob to the lowest point.

6. Clean the machine and keep it clean.

Precautions for constant temperature oscillator in cooling water bath:

edit

1. The working plane of the machine cannot be excessively smooth.

2. The electrical rated parameters of the socket provided by the user should not be less than the electrical rated parameters of the machine, and there should be good grounding measures.

3. The whole machine is strictly prohibited from being used in an environment with direct sunlight.

4. The speed control should start slowly from low speed to high speed.

5. The machine may experience some displacement during high-speed oscillation, so it should be monitored by someone during use.