CKD Pneumatic Component AX4075TS-B-DM04-P1-S-U0

CKD Pneumatic Component AX4075TS-B-DM04-P1-S-U0It is a component that does work through the pressure or expansion of gas, converting the elastic energy of compressed air into kinetic energy.

CKD Pneumatic Component AX4075TS-B-DM04-P1-S-U0A component that performs work by converting the elastic energy of compressed air into kinetic energy through the force generated by the pressure or expansion of air. Pneumatic components are a form of power transmission and energy conversion device that uses gas pressure to transmit energy.

Advantages of pneumatic components:

1. The pneumatic device has a simple structure, is lightweight, and easy to install and maintain. The medium is air, which is less flammable compared to hydraulic media, so it is safe to use.

2. The working medium is inexhaustible air, and air itself does not cost money. The exhaust treatment is simple, does not pollute the environment, and has low cost.

3. The adjustment of output force and working speed is very easy.

How to maintain?

1. Ensure the correct replacement gas supply system: The inlet pressure at the tool inlet (not the outlet pressure of the air compressor) is generally 90PSIG (6.2Kg/cm ^ 2). Too high or too low can damage the performance and service life of the tool. The intake must contain sufficient lubricating oil to ensure adequate lubrication of the pneumatic motor inside the tool. The intake must be completely free of moisture, and it is not appropriate to compress the air without passing it through an air dryer.

2. Do not dismantle the parts of the tool arbitrarily before operation, as it may affect the safety of the operator and cause damage to the tool.

3. If the tool has a slight malfunction or cannot achieve its original function after use, it should not be used again and should be checked immediately.

4. When using various tools, it is necessary to follow various safety regulations and instructions for use.

5. Proper tools should be selected for work. Tools that are too large can easily cause work-related injuries, while tools that are too small can easily cause damage to the tools.

6. Regularly (approximately once a week) inspect and maintain tools, add butter to rotating parts such as bearings, and add engine oil to pneumatic motor parts.