Maintenance Methods for Stainless Steel Distillers-Chemical Instrument Network

1First, close the drain valve.

2Open the water source valve to allow tap water to enter the condenser through the inlet control valve, and then inject it into the evaporator through the return pipe. Until the water level rises and overflows at the water pipe.

3Connect the power, wait until the water in the pot is boiling, and then turn on the large water source valve（1）. However, it should be noted that the water flow should not be too large or too small. The water source valve should be gradually opened from small to large and adjusted to the maximum distilled water output.

4The distilled water outlet pipe is equipped with a smooth silicone rubber conduit, which leads into clean glass distilled water.

5Before use, the interior should be washed once a day, and any remaining water should be drained and replaced with fresh water to ensure water quality.

6The scale inside the distilled water tank can be washed with weak acid or weak alkali solution for easy removal.

7Newly purchased distilled water dispensers should be cleaned first and undergo2Evaporate with electricity for more than hours until distilled water meets drug testing requirements.