What isCyclic corrosion test chamber
The cyclic corrosion test chamber aims to become a more practical salt spray testing method than traditional static exposure. Because there are usually two types of atmospheric exposure: dry and wet, accelerating laboratory testing to simulate natural circulation conditions is meaningful. Research has shown that in the cyclic corrosion test chamber, the relative corrosion rate, structure, and morphology are more similar to those in outdoor conditions. Therefore, compared with conventional salt spray testing, cyclic testing usually has a stronger correlation with outdoor environments and can effectively evaluate various corrosion mechanisms (including conventional corrosion, electrical corrosion, and contact corrosion).
Cyclic corrosion test chamberDesign advantages:
Easy to operate: The Q-FOG CCT salt spray cyclic corrosion test chamber can run the following four test cycles: salt spray cycle, dry cycle, 100% humidity cycle, and static cycle. The testing conditions, including time and temperature, can be set through a user-friendly built-in microprocessor. The setting and operation of the program are very convenient, and the operator can quickly read and add new cycles or select any preset cycle test program. At the same time, a timer can be set to sound an alarm or terminate the test process. The controller will continuously display the current test conditions and progress
Cyclic corrosion test chamberFeatures:
1. Various complex and typical corrosion environments can be reproduced in a salt spray test chamber. Cycle under three or four conditions: spray, dry, 100% humidity, and static (pause).
2. Easy to develop cyclic programs or directly run the built-in testing program of the cyclic corrosion test chamber. Many cyclic corrosion tests can be completed, such as Prohesion test, ASTM B117, ASTM G85, BS3900 F4 and F9, DIN50.907, and ISO9227 tests. Built in all or part of the following loop programs: 1. Cycle A, ASTM B117 (NSS) 2. Cycle B, Prohesion3, Cycle C, CCT-14, Cycle D, CCT-IV5, Cycle E, GM9540P/B6, Cycle F, ASTM B368 (CASS)
3. Quickly
Cyclic corrosion test chamberThanks to the built-in heater and large capacity dry cooling blower, the temperature of the box can be quickly changed.
4. The all plastic structure cyclic corrosion test chamber is made of sturdy fiber-reinforced plastic, which is corrosion-resistant and does not cause contamination to the specimen. Durable materials are beneficial for accurate temperature control.
5. Self diagnostic function, easy to maintain.
6. Compared with ordinary testing machine, the spray controlled cyclic corrosion test chamber has better atomization and dispersion effect, and can independently adjust the spray amount and spray distance.
7. The reliability cyclic corrosion test chamber is equipped with the following safety sensors. Once a fault occurs, these detectors will send a signal to the controller and stop the operation of the corresponding components. Chassis overheat circuit breaker, bubble tower overheat circuit breaker, steam generator overheat circuit breaker, air heater circuit breaker, bubble tower low water level sensor, bubble tower high water level sensor, steam generator water level sensor, solution storage tank low water level sensor.
