Ultrasonic cell disruptorIt is a device that converts electrical energy into sound energy through a transducer, and this energy is transformed into dense small bubbles through a liquid medium. When these small bubbles quickly burst, they release energy similar to a small bomb, thereby achieving the effect of breaking cells and other substances.
Technical characteristics:
1. It stimulates the ultrasonic circuit, allowing for continuous and uninterrupted ultrasound, automatic tracking of frequency and resonance point, and power control, without the need for frequent manual energy adjustment.
2. Working mode: 7-inch touch screen touch operation, simple and convenient operation; Real time display of working parameters on the screen and cumulative display of operating status; The microprocessor controller can store working programs, and the 9999 minute process control timer controls the total time: adjustable from 0.1 seconds to 9999 minutes.
3. The ultrasonic frequency converter adopts lead zirconate titanate crystal piezoelectric frequency converter, which is sealed to isolate water vapor and corrosive gases.
4. On/off pulse timer, both closed cycle and open cycle can be set from 1 second to 99 seconds to ensure high-intensity processing of samples.
5. The automatic amplitude and pulse compensation function ensures that the probe amplitude does not change due to changes in load during the ultrasound process.
6. The transducer is made of German IBDI ceramic chip material, which has high ultrasonic efficiency and is not easy to generate heat after long-term operation.
7. The ultrasonic probe is made of American standard TC4 titanium alloy material, which is not prone to wear and cavitation after long-term use (on-site verification is required, and the probe will not be damaged after continuous ultrasound for 30 minutes).
8. The equipment can work intermittently or run without load, which meets different experimental requirements and needs to be verified (10 minutes of no-load ultrasound is qualified).
9. Integrated design of the whole machine, with automatic lifting function, UV sterilization, and lighting function.
Cleaning operation procedures:
Before each use, place the probe in purified water and sonicate for a few seconds to remove any residue; Thoroughly clean every 3 months.
Maintenance and upkeep operating procedures:
After using the probe for a period of time, honeycomb like structures may appear. At this time, it is necessary to file it flat with a file, otherwise it will affect the crushing effect. The machine surface and probe should be cleaned regularly and kept clean. When not in use for a long time, the power plug should be unplugged.