CBY100-1.0 electronic extensometer

Technical Features：

Full bridge, 350 ohm strain design, compatible with the measurement and control system of the testing machine;

Suitable for tensile and compression testing, as well as deformation measurement in cyclic testing;

Bidirectional overtravel mechanical limit;

Meet the national standard GB/T12160-2002 and also meet the accuracy requirements of the existing ASTM B-1 level and ISO9513 0.5 level;

The hard alloy steel blade is easy to replace;

The extensometer can be selected according to the temperature range, and the applicable temperature range is -40 ° C to+100 ° C;

The product packaging adopts aluminum alloy portable case;

Easy maintenance and replacement of parts;

Adopting a sturdy double bending elastic structure design, it can be used for high-frequency cyclic testing;

Install the extensometer onto the specimen by wrapping it with a spring or rubber band;

CBY100-1.0 electronic extensometerUniversal extensometer, suitable for deformation measurement in axial tension, compression, and cyclic tests.

Range of gauge length; 12.5—500mm， Range of deformation; 2.5—25mm.

CBY100-1.0 electronic extensometerDesigned with strain gauges, it is compatible with any electronic component suitable for strain gauge sensors. Usually they are connected to the measurement controller of the testing machine, and the signal conditioning electronic components of the extensometer are usually included in the measurement controller of the testing machine, or an acquisition system can be added. (It can also be displayed digitally or recorded manually).

Depending on the specific situation, the extensometer can provide both connectors and connections for direct insertion into electronic components.

Selection criteria;

Can connect specific requirements for testing machine system connectors and wiring sequence.

Special blade.

Gauge length (mm)	Range (mm)	Accuracy (level)	Temperature (°C)	blade
12.5	0—25	0.5——1	One 40 one+100	Straight line, circle, V-shaped cutting edge
25	0—25	0.5——1	One 40 one+100	Straight line, circle, V-shaped cutting edge
50	0—25	0.5——1	One 40 one+100	Straight line, circle, V-shaped cutting edge
100—500	0—25	0.5——1	One 40 one+100	Straight line, circle, V-shaped cutting edge

technical scope：

excitation; It is recommended to use 5-10 volts DC voltage, with a higher voltage of 12 volts DC or AC voltage.

Output; Rated 1.5-4mV/V, depending on the product model.

Temperature range; The standard type is -40 ° C -+100 ° C.

wireway; Flexible wire, standard length 2.5m.

The standard is quickly applicable to circular specimens with a larger diameter of 1-45mm, and can be used for larger flat specimens after installing the transverse axis; 10-30mm thick, 15-40mm wide.