Whole shoe dynamic anti-skid testing machineUsed for testing the dynamic anti slip performance of the entire shoe or sole; Simulate various possible situations that are most likely to cause slipping during real walking. The testing machine adopts a high-speed force measurement system, a motion system, and excellent testing software. The instrument has high precision and good repeatability, and is widely used by many individual protection, quality inspection, military, foreign-funded shoe testing centers, research institutions, and enterprises.

　　Characteristics of dynamic anti-skid testing machine for whole shoes：

1. The whole machine testing has high precision and good repeatability;

2. Proportional valve control and high-speed response motion system, program setting, automatic pressurization;

3. High speed acquisition system and testing software, with built-in standard testing methods for direct access;

4. Provide customized sample lasts, reliable sample installation, and improve testing process repeatability;

5. Diversified testing interfaces for stainless steel plates, tiles, etc., simulate different testing requirements;

6. Provide standard comparison rubber for verifying the friction coefficient of the testing interface and the accuracy of system testing.

　　Usage method of dynamic anti-skid testing machine for whole shoes：

1. Adjust the height of the lower sub disc: Loosen the locking nut counterclockwise (from a top view), rotate the rolling screw counterclockwise to raise the lower guide spindle until there is a gap of 1-2mm between the upper surface of the test ring and the lower surface of the upper sample;

2. Reverse the locking nut to eliminate the thread gap between the rolling screw and the upper force plate;

3. Select the friction pair, set the test force, test time, maximum friction torque (alarm and stop when exceeding the maximum value), and spindle speed;

4. Click on the 'reset' button for the test force;

5. Click the "Load" button to load the test force;

6. To measure temperature, press the power button on the temperature controller on the board and plug in the temperature sensor. Click the "Start Temperature Measurement" button on the main page to display the temperature in real-time;

7. Click on "Reset Friction";

8. Click the "Start" button, and the spindle will start rotating, marking the start of the experiment;

To stop the machine midway, click the "Stop" button on the main page;

During the experiment, the software automatically controls the test force and temperature at the set values. Real time collection of friction torque and spindle speed, calculation of friction coefficient, display of experimental time and temperature; When the experimental time is up, the testing machine will automatically shut down.