Maintenance and upkeep of oscillation incubator:

1. Accurately using and paying attention to the maintenance of instruments to keep them in good working condition can extend their service life.

During continuous operation, the instrument should undergo regular inspections every three months; Check the fuse, control components and fastening screws, and whether there are water droplets, dirt, etc. falling onto the motor and control components.

3. The bearings of the transmission part have been filled with an appropriate amount of lubricating grease (No. 1 calcium nano base) before leaving the factory. During continuous operation of the instrument, lubricating grease should be added every six months, with a filling amount of about one-third of the bearing space.

4. The instrument is frequently used and natural wear and tear is a normal phenomenon. After one year of use, if abnormal noise is found in the motor or compressor of the instrument; We will inherit and provide services to assist in handling faults such as bearing wear in the transmission part, loose or cracked belts, and failure of electronic control components.

5. The compressor should avoid continuous starting.