Instructions for using a multifunctional abrasive particle analyzer

Multi functional abrasive particle analyzerLNF Q230 follows and meets the ASTM D7596 standard, which enables rapid qualitative and quantitative analysis of equipment wear (quantitative monitoring of total ferromagnetic particles and counting of large-sized ferromagnetic particles), equipment wear causes (intelligent abrasive identification and classification, i.e. intelligent ferrography technology), and oil contamination level (oil contamination level, ISO, NAS contamination level).

Multi functional abrasive particle analyzerdetection content

1. Ferromagnetic particle detection (equipment wear degree detection)
Built in high-sensitivity magnetic sensor can detect the concentration of ferromagnetic particles (ppm) and the total number and size of ferromagnetic particles larger than 25um.

2. Automatic classification of abrasive particles (i.e. iron spectrum analysis function, wear traceability analysis)
Automatically classify the abrasive particles in the lubricating oil into metal abrasive particles and non-metal abrasive particles according to the wear reasons of the equipment, and classify the abrasive particles into cutting wear, contact/sliding wear, fatigue wear, etc; Non metallic abrasive particles are mainly divided into fibers, bubbles, water droplets, etc.

3. Particle count (i.e. degree of oil contamination)
By directly capturing the morphological characteristics of various solid mechanical particles, the size and quantity of abrasive particles are automatically calculated, and the pollution level of the oil is automatically calculated according to ISO, NAS, and mainstream pollution evaluation standards.