SMC * CRB2BW10-180S rotary cylinder*

Internal and external leaks in a cylinder are generally caused by eccentric installation of the piston rod, insufficient supply of lubricating oil, wear or damage to the sealing ring and sealing ring, impurities in the cylinder, and scratches on the piston rod. Therefore, when there is internal or external leakage in the cylinder, the center of the piston rod should be readjusted to ensure the coaxiality between the piston rod and the cylinder barrel; Regularly check the reliability of the oil mist device to ensure good lubrication of the actuator components; When the sealing ring and sealing ring are worn or damaged, they must be replaced in a timely manner; If there are impurities in the cylinder, they should be removed in a timely manner; When there are scars on the piston rod, it should be replaced with a new one.

The insufficient output force and unstable movement of the cylinder are generally caused by the piston or piston rod being stuck, poor lubrication, insufficient air supply, or condensation water and impurities in the cylinder. For this, the center of the piston rod should be adjusted; Check whether the operation of the oil mist device is reliable; Is the gas supply pipeline blocked. When there is condensed water and impurities in the cylinder, they should be removed in a timely manner.

The poor buffering effect of the cylinder is generally caused by wear of the buffering sealing ring or damage to the adjusting screw. At this point, the sealing ring and adjusting screw should be replaced.

Damage to the piston rod and cylinder head of a cylinder is usually caused by eccentric installation of the piston rod or ineffective buffering mechanism. For this, the center position of the piston rod should be adjusted; Replace the buffer seal ring or adjust the screw.

SMC * CRB2BW10-180S rotary cylinder*